mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-11 23:47:24 +00:00
71025f013c
The spi-mem layer provides a spi_mem_supports_op() function to check
whether a specific operation is supported by the controller or not.
This is much more accurate than the hwcaps selection logic based on
SPI_{RX,TX}_ flags.
Rework the hwcaps selection logic to use spi_mem_supports_op().
To make sure the build doesn't break for boards not using CONFIG_DM_SPI,
add a simple SPI_{RX,TX}_ based hwcaps selection logic in spi-mem-nodm
similar to spi_mem_default_supports_op(). This change is only
compile-tested.
To avoid SPL size problems on the x530 board, the old hwcaps selection
is still kept around. Leaving the code in-place was getting difficult to
read and understand, so the code is restructured to have it all in one
isolated function. As a result of this, the parameter hwcaps to
spi_nor_setup() is no longer needed. Remove it.
Based on the Linux commit c76f5089796a (mtd: spi-nor: Rework hwcaps
selection for the spi-mem case, 2019-08-06)
Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>
|
||
|---|---|---|
| .. | ||
| bbm.h | ||
| cfi.h | ||
| concat.h | ||
| doc2000.h | ||
| flashchip.h | ||
| fsl_upm.h | ||
| fsmc_nand.h | ||
| mtd.h | ||
| nand.h | ||
| nand_bch.h | ||
| nand_ecc.h | ||
| ndfc.h | ||
| omap_elm.h | ||
| omap_gpmc.h | ||
| onenand.h | ||
| onenand_regs.h | ||
| partitions.h | ||
| rawnand.h | ||
| samsung_onenand.h | ||
| spi-nor.h | ||
| spinand.h | ||
| st_smi.h | ||
| ubi.h | ||