u-boot/configs/cm_t54_defconfig
Tom Rini 6f6b7cfa89 Convert all of CONFIG_CONS_INDEX to Kconfig
This converts the following to Kconfig:
   CONFIG_CONS_INDEX

We have existing entries for this option in a number of places, with
different guards on them.  They're also sometimes used for things not
directly inside of the serial driver.  First, introduce a new symbol to
guard the use of CONFIG_CONS_INDEX, so that in the case where we don't
need this for the serial driver, but for some other use, we can still do
it.  Next, consolidate all of these into the single entry in
drivers/serial/Kconfig.  Finally, introduce CONS_INDEX_[023456] so that
we can imply a correct value here to make the defconfig side of this
smaller.

Signed-off-by: Adam Ford <aford173@gmail.com>
[trini: Rework a lot of the logic here, such that I took authorship from
Adam, but kept his S-o-B line]
Signed-off-by: Tom Rini <trini@konsulko.com>
2018-03-16 10:28:52 -04:00

45 lines
1.1 KiB
Text

CONFIG_ARM=y
CONFIG_ARCH_OMAP2PLUS=y
CONFIG_OMAP54XX=y
CONFIG_TARGET_CM_T54=y
CONFIG_OMAP_PLATFORM_RESET_TIME_MAX_USEC=16296
# CONFIG_SPL_NAND_SUPPORT is not set
CONFIG_DISTRO_DEFAULTS=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_BOOTDELAY=3
# CONFIG_USE_BOOTCOMMAND is not set
CONFIG_SYS_CONSOLE_INFO_QUIET=y
CONFIG_VERSION_VARIABLE=y
CONFIG_SPL=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x200
CONFIG_SPL_SATA_SUPPORT=y
CONFIG_SYS_PROMPT="CM-T54 # "
CONFIG_CMD_ASKENV=y
CONFIG_CMD_EEPROM=y
CONFIG_CMD_EEPROM_LAYOUT=y
CONFIG_EEPROM_LAYOUT_HELP_STRING="v2, v3"
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_SPI=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SETEXPR is not set
# CONFIG_CMD_NFS is not set
CONFIG_CMD_EXT4_WRITE=y
CONFIG_ENV_IS_IN_MMC=y
CONFIG_SCSI_AHCI=y
CONFIG_MMC_OMAP_HS=y
CONFIG_SCSI=y
CONFIG_CONS_INDEX=4
CONFIG_SYS_NS16550=y
CONFIG_OMAP3_SPI=y
CONFIG_USB=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_STORAGE=y
CONFIG_USB_HOST_ETHER=y
CONFIG_USB_ETHER_ASIX=y
CONFIG_USB_ETHER_MCS7830=y
CONFIG_USB_ETHER_SMSC95XX=y
CONFIG_FAT_WRITE=y
CONFIG_OF_LIBFDT=y