u-boot/board/nvidia/dts/tegra20-harmony.dts
Stephen Warren 699c40e878 ARM: tegra: Harmony: enable ULPI USB port
The ULPI port is routed onto pins on the mini PCI Express connector. A
standard breakout board may be used to access the port.

* Add required DT entries to configure the ULPI port.
* Setup up the ULPI pinmux in the board code.
* Enable multiple USB controller and ULPI support in the board config.

Signed-off-by: Stephen Warren <swarren@nvidia.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>
2012-10-29 09:07:04 -07:00

68 lines
1,013 B
Text

/dts-v1/;
/include/ ARCH_CPU_DTS
/ {
model = "NVIDIA Tegra20 Harmony evaluation board";
compatible = "nvidia,harmony", "nvidia,tegra20";
aliases {
usb0 = "/usb@c5008000";
usb1 = "/usb@c5004000";
};
memory {
reg = <0x00000000 0x40000000>;
};
clocks {
clk_32k: clk_32k {
clock-frequency = <32000>;
};
osc {
clock-frequency = <12000000>;
};
};
clock@60006000 {
clocks = <&clk_32k &osc>;
};
serial@70006300 {
clock-frequency = < 216000000 >;
};
i2c@7000c000 {
status = "disabled";
};
i2c@7000c400 {
status = "disabled";
};
i2c@7000c500 {
status = "disabled";
};
i2c@7000d000 {
status = "disabled";
};
usb@c5000000 {
status = "disabled";
};
usb@c5004000 {
nvidia,phy-reset-gpio = <&gpio 169 0>; /* gpio PV1 */
};
nand-controller@70008000 {
nvidia,wp-gpios = <&gpio 23 0>; /* PC7 */
nvidia,width = <8>;
nvidia,timing = <26 100 20 80 20 10 12 10 70>;
nand@0 {
reg = <0>;
compatible = "hynix,hy27uf4g2b", "nand-flash";
};
};
};