mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-12-27 05:23:34 +00:00
2ea79a98c4
Add board_mmc_get_env_dev Switch the mmc env based on the mmc devno, instead of separately defining a config item in include/configs using board_mmc_get_env_dev - devno 0: sd/esd - devno 1: mmc/emmc Cc: Stefano Babic <sbabic@denx.de> Cc: Matteo Lisi <matteo.lisi@engicam.com> Cc: Michael Trimarchi <michael@amarulasolutions.com> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> |
||
|---|---|---|
| .. | ||
| icorem6_rqs.c | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
How to use U-Boot on Engicam i.CoreM6 RQS Solo/DualLite and Quad/Dual Starter Kit: ---------------------------------------------------------------------------------- $ make mrproper - Configure U-Boot for Engicam i.CoreM6 RQS Quad/Dual: $ make imx6q_icore_rqs_mmc_defconfig - Configure U-Boot for Engicam i.CoreM6 RQS Solo/DualLite: $ make imx6dl_icore_rqs_mmc_defconfig - Build U-Boot $ make This will generate the SPL image called SPL and the u-boot-dtb.img. - Flash the SPL image into the micro SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot-dtb.img image into the micro SD card: sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Jumper settings: MMC Boot: JM3 Closed - Connect the Serial cable between the Starter Kit and the PC for the console. (J28 is the Linux Serial console connector) - Insert the micro SD card in the board, power it up and U-Boot messages should come up.