u-boot/drivers/mtd/nand/fsl_ifc_spl.c
Alison Wang 8ab967b6c6 arm: ls102xa: Add NAND boot support for LS1021AQDS board
This patch adds NAND boot support for LS1021AQDS board. SPL
framework is used. PBL initialize the internal RAM and copy
SPL to it, then SPL initialize DDR using SPD and copy u-boot
from NAND flash to DDR, finally SPL transfer control to u-boot.

Signed-off-by: Prabhakar Kushwaha <prabhakar@freescale.com>
Signed-off-by: Alison Wang <alison.wang@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
2014-12-11 09:40:24 -08:00

266 lines
6.3 KiB
C

/*
* NAND boot for Freescale Integrated Flash Controller, NAND FCM
*
* Copyright 2011 Freescale Semiconductor, Inc.
* Author: Dipen Dudhat <dipen.dudhat@freescale.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/io.h>
#include <fsl_ifc.h>
#include <linux/mtd/nand.h>
static inline int is_blank(uchar *addr, int page_size)
{
int i;
for (i = 0; i < page_size; i++) {
if (__raw_readb(&addr[i]) != 0xff)
return 0;
}
/*
* For the SPL, don't worry about uncorrectable errors
* where the main area is all FFs but shouldn't be.
*/
return 1;
}
/* returns nonzero if entire page is blank */
static inline int check_read_ecc(uchar *buf, u32 *eccstat,
unsigned int bufnum, int page_size)
{
u32 reg = eccstat[bufnum / 4];
int errors = (reg >> ((3 - bufnum % 4) * 8)) & 0xf;
if (errors == 0xf) { /* uncorrectable */
/* Blank pages fail hw ECC checks */
if (is_blank(buf, page_size))
return 1;
puts("ecc error\n");
for (;;)
;
}
return 0;
}
static inline void nand_wait(uchar *buf, int bufnum, int page_size)
{
struct fsl_ifc *ifc = IFC_BASE_ADDR;
u32 status;
u32 eccstat[4];
int bufperpage = page_size / 512;
int bufnum_end, i;
bufnum *= bufperpage;
bufnum_end = bufnum + bufperpage - 1;
do {
status = ifc_in32(&ifc->ifc_nand.nand_evter_stat);
} while (!(status & IFC_NAND_EVTER_STAT_OPC));
if (status & IFC_NAND_EVTER_STAT_FTOER) {
puts("flash time out error\n");
for (;;)
;
}
for (i = bufnum / 4; i <= bufnum_end / 4; i++)
eccstat[i] = ifc_in32(&ifc->ifc_nand.nand_eccstat[i]);
for (i = bufnum; i <= bufnum_end; i++) {
if (check_read_ecc(buf, eccstat, i, page_size))
break;
}
ifc_out32(&ifc->ifc_nand.nand_evter_stat, status);
}
static inline int bad_block(uchar *marker, int port_size)
{
if (port_size == 8)
return __raw_readb(marker) != 0xff;
else
return __raw_readw((u16 *)marker) != 0xffff;
}
int nand_spl_load_image(uint32_t offs, unsigned int uboot_size, void *vdst)
{
struct fsl_ifc *ifc = IFC_BASE_ADDR;
uchar *buf = (uchar *)CONFIG_SYS_NAND_BASE;
int page_size;
int port_size;
int pages_per_blk;
int blk_size;
int bad_marker = 0;
int bufnum_mask, bufnum, ver = 0;
int csor, cspr;
int pos = 0;
int j = 0;
int sram_addr;
int pg_no;
uchar *dst = vdst;
/* Get NAND Flash configuration */
csor = CONFIG_SYS_NAND_CSOR;
cspr = CONFIG_SYS_NAND_CSPR;
port_size = (cspr & CSPR_PORT_SIZE_16) ? 16 : 8;
if ((csor & CSOR_NAND_PGS_MASK) == CSOR_NAND_PGS_8K) {
page_size = 8192;
bufnum_mask = 0x0;
} else if ((csor & CSOR_NAND_PGS_MASK) == CSOR_NAND_PGS_4K) {
page_size = 4096;
bufnum_mask = 0x1;
} else if ((csor & CSOR_NAND_PGS_MASK) == CSOR_NAND_PGS_2K) {
page_size = 2048;
bufnum_mask = 0x3;
} else {
page_size = 512;
bufnum_mask = 0xf;
if (port_size == 8)
bad_marker = 5;
}
ver = ifc_in32(&ifc->ifc_rev);
if (ver >= FSL_IFC_V2_0_0)
bufnum_mask = (bufnum_mask * 2) + 1;
pages_per_blk =
32 << ((csor & CSOR_NAND_PB_MASK) >> CSOR_NAND_PB_SHIFT);
blk_size = pages_per_blk * page_size;
/* Open Full SRAM mapping for spare are access */
ifc_out32(&ifc->ifc_nand.ncfgr, 0x0);
/* Clear Boot events */
ifc_out32(&ifc->ifc_nand.nand_evter_stat, 0xffffffff);
/* Program FIR/FCR for Large/Small page */
if (page_size > 512) {
ifc_out32(&ifc->ifc_nand.nand_fir0,
(IFC_FIR_OP_CW0 << IFC_NAND_FIR0_OP0_SHIFT) |
(IFC_FIR_OP_CA0 << IFC_NAND_FIR0_OP1_SHIFT) |
(IFC_FIR_OP_RA0 << IFC_NAND_FIR0_OP2_SHIFT) |
(IFC_FIR_OP_CMD1 << IFC_NAND_FIR0_OP3_SHIFT) |
(IFC_FIR_OP_BTRD << IFC_NAND_FIR0_OP4_SHIFT));
ifc_out32(&ifc->ifc_nand.nand_fir1, 0x0);
ifc_out32(&ifc->ifc_nand.nand_fcr0,
(NAND_CMD_READ0 << IFC_NAND_FCR0_CMD0_SHIFT) |
(NAND_CMD_READSTART << IFC_NAND_FCR0_CMD1_SHIFT));
} else {
ifc_out32(&ifc->ifc_nand.nand_fir0,
(IFC_FIR_OP_CW0 << IFC_NAND_FIR0_OP0_SHIFT) |
(IFC_FIR_OP_CA0 << IFC_NAND_FIR0_OP1_SHIFT) |
(IFC_FIR_OP_RA0 << IFC_NAND_FIR0_OP2_SHIFT) |
(IFC_FIR_OP_BTRD << IFC_NAND_FIR0_OP3_SHIFT));
ifc_out32(&ifc->ifc_nand.nand_fir1, 0x0);
ifc_out32(&ifc->ifc_nand.nand_fcr0,
NAND_CMD_READ0 << IFC_NAND_FCR0_CMD0_SHIFT);
}
/* Program FBCR = 0 for full page read */
ifc_out32(&ifc->ifc_nand.nand_fbcr, 0);
/* Read and copy u-boot on SDRAM from NAND device, In parallel
* check for Bad block if found skip it and read continue to
* next Block
*/
while (pos < uboot_size) {
int i = 0;
do {
pg_no = offs / page_size;
bufnum = pg_no & bufnum_mask;
sram_addr = bufnum * page_size * 2;
ifc_out32(&ifc->ifc_nand.row0, pg_no);
ifc_out32(&ifc->ifc_nand.col0, 0);
/* start read */
ifc_out32(&ifc->ifc_nand.nandseq_strt,
IFC_NAND_SEQ_STRT_FIR_STRT);
/* wait for read to complete */
nand_wait(&buf[sram_addr], bufnum, page_size);
/*
* If either of the first two pages are marked bad,
* continue to the next block.
*/
if (i++ < 2 &&
bad_block(&buf[sram_addr + page_size + bad_marker],
port_size)) {
puts("skipping\n");
offs = (offs + blk_size) & ~(blk_size - 1);
pos &= ~(blk_size - 1);
break;
}
for (j = 0; j < page_size; j++)
dst[pos + j] = __raw_readb(&buf[sram_addr + j]);
pos += page_size;
offs += page_size;
} while ((offs & (blk_size - 1)) && (pos < uboot_size));
}
return 0;
}
/*
* Main entrypoint for NAND Boot. It's necessary that SDRAM is already
* configured and available since this code loads the main U-boot image
* from NAND into SDRAM and starts from there.
*/
void nand_boot(void)
{
__attribute__((noreturn)) void (*uboot)(void);
/*
* Load U-Boot image from NAND into RAM
*/
nand_spl_load_image(CONFIG_SYS_NAND_U_BOOT_OFFS,
CONFIG_SYS_NAND_U_BOOT_SIZE,
(uchar *)CONFIG_SYS_NAND_U_BOOT_DST);
#ifdef CONFIG_NAND_ENV_DST
nand_spl_load_image(CONFIG_ENV_OFFSET, CONFIG_ENV_SIZE,
(uchar *)CONFIG_NAND_ENV_DST);
#ifdef CONFIG_ENV_OFFSET_REDUND
nand_spl_load_image(CONFIG_ENV_OFFSET_REDUND, CONFIG_ENV_SIZE,
(uchar *)CONFIG_NAND_ENV_DST + CONFIG_ENV_SIZE);
#endif
#endif
/*
* Jump to U-Boot image
*/
#ifdef CONFIG_SPL_FLUSH_IMAGE
/*
* Clean d-cache and invalidate i-cache, to
* make sure that no stale data is executed.
*/
flush_cache(CONFIG_SYS_NAND_U_BOOT_DST, CONFIG_SYS_NAND_U_BOOT_SIZE);
#endif
uboot = (void *)CONFIG_SYS_NAND_U_BOOT_START;
uboot();
}
#ifndef CONFIG_SPL_NAND_INIT
void nand_init(void)
{
}
void nand_deselect(void)
{
}
#endif