mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-14 08:57:58 +00:00
ac242e1625
If the system boots from NAND, make sure to de-assert the NAND IP reset, otherwise the system will get stuck. Signed-off-by: Marek Vasut <marex@denx.de> Cc: Dinh Nguyen <dinguyen@opensource.altera.com>
184 lines
4.8 KiB
C
184 lines
4.8 KiB
C
/*
|
|
* Copyright (C) 2012 Altera Corporation <www.altera.com>
|
|
*
|
|
* SPDX-License-Identifier: GPL-2.0+
|
|
*/
|
|
|
|
#include <common.h>
|
|
#include <asm/io.h>
|
|
#include <asm/pl310.h>
|
|
#include <asm/u-boot.h>
|
|
#include <asm/utils.h>
|
|
#include <image.h>
|
|
#include <asm/arch/reset_manager.h>
|
|
#include <spl.h>
|
|
#include <asm/arch/system_manager.h>
|
|
#include <asm/arch/freeze_controller.h>
|
|
#include <asm/arch/clock_manager.h>
|
|
#include <asm/arch/scan_manager.h>
|
|
#include <asm/arch/sdram.h>
|
|
#include <asm/arch/scu.h>
|
|
#include <asm/arch/nic301.h>
|
|
|
|
DECLARE_GLOBAL_DATA_PTR;
|
|
|
|
static struct pl310_regs *const pl310 =
|
|
(struct pl310_regs *)CONFIG_SYS_PL310_BASE;
|
|
static struct scu_registers *scu_regs =
|
|
(struct scu_registers *)SOCFPGA_MPUSCU_ADDRESS;
|
|
static struct nic301_registers *nic301_regs =
|
|
(struct nic301_registers *)SOCFPGA_L3REGS_ADDRESS;
|
|
static struct socfpga_system_manager *sysmgr_regs =
|
|
(struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS;
|
|
|
|
u32 spl_boot_device(void)
|
|
{
|
|
const u32 bsel = readl(&sysmgr_regs->bootinfo);
|
|
|
|
switch (bsel & 0x7) {
|
|
case 0x1: /* FPGA (HPS2FPGA Bridge) */
|
|
return BOOT_DEVICE_RAM;
|
|
case 0x2: /* NAND Flash (1.8V) */
|
|
case 0x3: /* NAND Flash (3.0V) */
|
|
socfpga_per_reset(SOCFPGA_RESET(NAND), 0);
|
|
return BOOT_DEVICE_NAND;
|
|
case 0x4: /* SD/MMC External Transceiver (1.8V) */
|
|
case 0x5: /* SD/MMC Internal Transceiver (3.0V) */
|
|
socfpga_per_reset(SOCFPGA_RESET(SDMMC), 0);
|
|
socfpga_per_reset(SOCFPGA_RESET(DMA), 0);
|
|
return BOOT_DEVICE_MMC1;
|
|
case 0x6: /* QSPI Flash (1.8V) */
|
|
case 0x7: /* QSPI Flash (3.0V) */
|
|
socfpga_per_reset(SOCFPGA_RESET(QSPI), 0);
|
|
return BOOT_DEVICE_SPI;
|
|
default:
|
|
printf("Invalid boot device (bsel=%08x)!\n", bsel);
|
|
hang();
|
|
}
|
|
}
|
|
|
|
#ifdef CONFIG_SPL_MMC_SUPPORT
|
|
u32 spl_boot_mode(void)
|
|
{
|
|
#if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT)
|
|
return MMCSD_MODE_FS;
|
|
#else
|
|
return MMCSD_MODE_RAW;
|
|
#endif
|
|
}
|
|
#endif
|
|
|
|
static void socfpga_nic301_slave_ns(void)
|
|
{
|
|
writel(0x1, &nic301_regs->lwhps2fpgaregs);
|
|
writel(0x1, &nic301_regs->hps2fpgaregs);
|
|
writel(0x1, &nic301_regs->acp);
|
|
writel(0x1, &nic301_regs->rom);
|
|
writel(0x1, &nic301_regs->ocram);
|
|
writel(0x1, &nic301_regs->sdrdata);
|
|
}
|
|
|
|
void board_init_f(ulong dummy)
|
|
{
|
|
#ifndef CONFIG_SOCFPGA_VIRTUAL_TARGET
|
|
const struct cm_config *cm_default_cfg = cm_get_default_config();
|
|
#endif
|
|
unsigned long sdram_size;
|
|
unsigned long reg;
|
|
|
|
/*
|
|
* First C code to run. Clear fake OCRAM ECC first as SBE
|
|
* and DBE might triggered during power on
|
|
*/
|
|
reg = readl(&sysmgr_regs->eccgrp_ocram);
|
|
if (reg & SYSMGR_ECC_OCRAM_SERR)
|
|
writel(SYSMGR_ECC_OCRAM_SERR | SYSMGR_ECC_OCRAM_EN,
|
|
&sysmgr_regs->eccgrp_ocram);
|
|
if (reg & SYSMGR_ECC_OCRAM_DERR)
|
|
writel(SYSMGR_ECC_OCRAM_DERR | SYSMGR_ECC_OCRAM_EN,
|
|
&sysmgr_regs->eccgrp_ocram);
|
|
|
|
memset(__bss_start, 0, __bss_end - __bss_start);
|
|
|
|
socfpga_nic301_slave_ns();
|
|
|
|
/* Configure ARM MPU SNSAC register. */
|
|
setbits_le32(&scu_regs->sacr, 0xfff);
|
|
|
|
/* Remap SDRAM to 0x0 */
|
|
writel(0x1, &nic301_regs->remap); /* remap.mpuzero */
|
|
writel(0x1, &pl310->pl310_addr_filter_start);
|
|
|
|
#ifndef CONFIG_SOCFPGA_VIRTUAL_TARGET
|
|
debug("Freezing all I/O banks\n");
|
|
/* freeze all IO banks */
|
|
sys_mgr_frzctrl_freeze_req();
|
|
|
|
/* Put everything into reset but L4WD0. */
|
|
socfpga_per_reset_all();
|
|
/* Put FPGA bridges into reset too. */
|
|
socfpga_bridges_reset(1);
|
|
|
|
socfpga_per_reset(SOCFPGA_RESET(SDR), 0);
|
|
socfpga_per_reset(SOCFPGA_RESET(UART0), 0);
|
|
socfpga_per_reset(SOCFPGA_RESET(OSC1TIMER0), 0);
|
|
|
|
timer_init();
|
|
|
|
debug("Reconfigure Clock Manager\n");
|
|
/* reconfigure the PLLs */
|
|
cm_basic_init(cm_default_cfg);
|
|
|
|
/* Enable bootrom to configure IOs. */
|
|
sysmgr_config_warmrstcfgio(1);
|
|
|
|
/* configure the IOCSR / IO buffer settings */
|
|
if (scan_mgr_configure_iocsr())
|
|
hang();
|
|
|
|
sysmgr_config_warmrstcfgio(0);
|
|
|
|
/* configure the pin muxing through system manager */
|
|
sysmgr_config_warmrstcfgio(1);
|
|
sysmgr_pinmux_init();
|
|
sysmgr_config_warmrstcfgio(0);
|
|
|
|
#endif /* CONFIG_SOCFPGA_VIRTUAL_TARGET */
|
|
|
|
/* De-assert reset for peripherals and bridges based on handoff */
|
|
reset_deassert_peripherals_handoff();
|
|
socfpga_bridges_reset(0);
|
|
|
|
debug("Unfreezing/Thaw all I/O banks\n");
|
|
/* unfreeze / thaw all IO banks */
|
|
sys_mgr_frzctrl_thaw_req();
|
|
|
|
/* enable console uart printing */
|
|
preloader_console_init();
|
|
|
|
if (sdram_mmr_init_full(0xffffffff) != 0) {
|
|
puts("SDRAM init failed.\n");
|
|
hang();
|
|
}
|
|
|
|
debug("SDRAM: Calibrating PHY\n");
|
|
/* SDRAM calibration */
|
|
if (sdram_calibration_full() == 0) {
|
|
puts("SDRAM calibration failed.\n");
|
|
hang();
|
|
}
|
|
|
|
sdram_size = sdram_calculate_size();
|
|
debug("SDRAM: %ld MiB\n", sdram_size >> 20);
|
|
|
|
/* Sanity check ensure correct SDRAM size specified */
|
|
if (get_ram_size(0, sdram_size) != sdram_size) {
|
|
puts("SDRAM size check failed!\n");
|
|
hang();
|
|
}
|
|
|
|
socfpga_bridges_reset(1);
|
|
|
|
/* Configure simple malloc base pointer into RAM. */
|
|
gd->malloc_base = CONFIG_SYS_TEXT_BASE + (1024 * 1024);
|
|
}
|