u-boot/doc/device-tree-bindings/spi/spi-stm32-qspi.txt
Neil Armstrong 5991d0e36d doc: device-tree-bindings: switch from spi-flash to jedec, spi-nor
Since all DTS files has been switched to "jedec,spi-nor", remove
the "spi-flash" compatible from the bindings examples.

Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
Reviewed-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
Reviewed-by: Rick Chen <rick@andestech.com>
Reviewed-by: Patrick Delaunay <Patrick.delaunay@st.com>
Reviewed-by: Jagan Teki <jagan@openedev.com>
2019-04-12 10:54:27 +05:30

39 lines
1.2 KiB
Text

STM32 QSPI controller device tree bindings
--------------------------------------------
Required properties:
- compatible : should be "st,stm32-qspi".
- reg : 1. Physical base address and size of SPI registers map.
2. Physical base address & size of mapped NOR Flash.
- spi-max-frequency : Max supported spi frequency.
- status : enable in requried dts.
Connected flash properties
--------------------------
- spi-max-frequency : Max supported spi frequency.
- spi-tx-bus-width : Bus width (number of lines) for writing (1-4)
- spi-rx-bus-width : Bus width (number of lines) for reading (1-4)
- memory-map : Address and size for memory-mapping the flash
Example:
qspi: quadspi@A0001000 {
compatible = "st,stm32-qspi";
#address-cells = <1>;
#size-cells = <0>;
reg = <0xA0001000 0x1000>, <0x90000000 0x10000000>;
reg-names = "QuadSPI", "QuadSPI-memory";
interrupts = <92>;
spi-max-frequency = <108000000>;
status = "okay";
qflash0: n25q128a {
#address-cells = <1>;
#size-cells = <1>;
compatible = "micron,n25q128a13", "jedec,spi-nor";
spi-max-frequency = <108000000>;
spi-tx-bus-width = <4>;
spi-rx-bus-width = <4>;
memory-map = <0x90000000 0x1000000>;
reg = <0>;
};
};