u-boot/arch/arm/dts/bcm2837-rpi-cm3-io3.dts
Simon Glass 9ae600e9e2 arm: rpi: Sync rpi dts files from Linux
Sync these files, obtained from Linux v5.15.

This adds a devicetree file for rpi_4 which was not there before.

Testing shows no change so far as I can see:
- boots to U-Boot prompt on rpi0, rpi2
- boots to distro on rpi3
- boots to distro on rpi4

I am assuming that syncing with Linux is safe, but the maintainer should
know for sure.

Signed-off-by: Simon Glass <sjg@chromium.org>
2021-12-23 10:24:39 -05:00

96 lines
1.7 KiB
Text

// SPDX-License-Identifier: GPL-2.0
/dts-v1/;
#include "bcm2837-rpi-cm3.dtsi"
#include "bcm283x-rpi-usb-host.dtsi"
/ {
compatible = "raspberrypi,3-compute-module", "brcm,bcm2837";
model = "Raspberry Pi Compute Module 3 IO board V3.0";
};
&gpio {
/*
* This is based on the official GPU firmware DT blob.
*
* Legend:
* "NC" = not connected (no rail from the SoC)
* "FOO" = GPIO line named "FOO" on the schematic
* "FOO_N" = GPIO line named "FOO" on schematic, active low
*/
gpio-line-names = "GPIO0",
"GPIO1",
"GPIO2",
"GPIO3",
"GPIO4",
"GPIO5",
"GPIO6",
"GPIO7",
"GPIO8",
"GPIO9",
"GPIO10",
"GPIO11",
"GPIO12",
"GPIO13",
"GPIO14",
"GPIO15",
"GPIO16",
"GPIO17",
"GPIO18",
"GPIO19",
"GPIO20",
"GPIO21",
"GPIO22",
"GPIO23",
"GPIO24",
"GPIO25",
"GPIO26",
"GPIO27",
"GPIO28",
"GPIO29",
"GPIO30",
"GPIO31",
"GPIO32",
"GPIO33",
"GPIO34",
"GPIO35",
"GPIO36",
"GPIO37",
"GPIO38",
"GPIO39",
"GPIO40",
"GPIO41",
"GPIO42",
"GPIO43",
"GPIO44",
"GPIO45",
"GPIO46",
"GPIO47",
/* Used by eMMC */
"SD_CLK_R",
"SD_CMD_R",
"SD_DATA0_R",
"SD_DATA1_R",
"SD_DATA2_R",
"SD_DATA3_R";
pinctrl-0 = <&gpioout &alt0>;
};
&hdmi {
hpd-gpios = <&expgpio 1 GPIO_ACTIVE_LOW>;
power-domains = <&power RPI_POWER_DOMAIN_HDMI>;
status = "okay";
};
&sdhost {
pinctrl-names = "default";
pinctrl-0 = <&sdhost_gpio48>;
bus-width = <4>;
status = "okay";
};
&uart0 {
pinctrl-names = "default";
pinctrl-0 = <&uart0_gpio14>;
status = "okay";
};