u-boot/configs/lx2160ardb_tfa_defconfig
Tom Rini 3371eddaa1 Convert CONFIG_USB_MAX_CONTROLLER_COUNT to Kconfig
This converts the following to Kconfig:
   CONFIG_USB_MAX_CONTROLLER_COUNT

Signed-off-by: Tom Rini <trini@konsulko.com>
2022-06-28 17:11:48 -04:00

113 lines
2.7 KiB
Text

CONFIG_ARM=y
CONFIG_SKIP_LOWLEVEL_INIT=y
CONFIG_GIC_V3_ITS=y
CONFIG_TARGET_LX2160ARDB=y
CONFIG_TFABOOT=y
CONFIG_SYS_TEXT_BASE=0x82000000
CONFIG_SYS_MALLOC_LEN=0x202000
CONFIG_SYS_MALLOC_F_LEN=0x6000
CONFIG_NR_DRAM_BANKS=3
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0x500000
CONFIG_ENV_SECT_SIZE=0x20000
CONFIG_DM_GPIO=y
CONFIG_DEFAULT_DEVICE_TREE="fsl-lx2160a-rdb"
CONFIG_FSL_USE_PCA9547_MUX=y
CONFIG_VID=y
CONFIG_SPL_VID=y
CONFIG_VID_FLS_ENV="lx2160ardb_vdd_mv"
CONFIG_VOL_MONITOR_LTC3882_READ=y
CONFIG_VOL_MONITOR_LTC3882_SET=y
CONFIG_FSL_QIXIS=y
CONFIG_EMC2305=y
CONFIG_FSPI_AHB_EN_4BYTE=y
CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
CONFIG_ENV_ADDR=0x20500000
CONFIG_AHCI=y
CONFIG_OF_BOARD_FIXUP=y
CONFIG_REMAKE_ELF=y
CONFIG_MP=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_DYNAMIC_SYS_CLK_FREQ=y
CONFIG_BOOTDELAY=10
CONFIG_USE_BOOTARGS=y
CONFIG_BOOTARGS="console=ttyAMA0,115200 root=/dev/ram0 earlycon=pl011,mmio32,0x21c0000 ramdisk_size=0x2000000 default_hugepagesz=1024m hugepagesz=1024m hugepages=2 pci=pcie_bus_perf"
CONFIG_MISC_INIT_R=y
CONFIG_RESET_PHY_R=y
CONFIG_SYS_MAXARGS=64
CONFIG_SYS_PBSIZE=532
CONFIG_CMD_GREPENV=y
CONFIG_CMD_EEPROM=y
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=3
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
CONFIG_CMD_DM=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_GPT=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_OPTEE_RPMB=y
CONFIG_CMD_PCI=y
CONFIG_CMD_USB=y
CONFIG_CMD_WDT=y
CONFIG_CMD_CACHE=y
CONFIG_OF_CONTROL=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_MMC=y
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_USE_ETHPRIME=y
CONFIG_ETHPRIME="DPMAC1@xgmii"
CONFIG_NET_RANDOM_ETHADDR=y
CONFIG_DM=y
CONFIG_SATA=y
CONFIG_SATA_CEVA=y
CONFIG_FSL_CAAM=y
CONFIG_DYNAMIC_DDR_CLK_FREQ=y
CONFIG_DIMM_SLOTS_PER_CTLR=2
CONFIG_DDR_ECC=y
CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
CONFIG_MPC8XXX_GPIO=y
CONFIG_DM_I2C=y
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
CONFIG_SYS_I2C_EEPROM_ADDR=0x57
CONFIG_SUPPORT_EMMC_RPMB=y
CONFIG_MMC_HS400_SUPPORT=y
CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_SPI_FLASH_MT35XU=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
CONFIG_PHY_ATHEROS=y
CONFIG_PHY_CORTINA=y
CONFIG_SYS_CORTINA_NO_FW_UPLOAD=y
CONFIG_DM_ETH=y
CONFIG_DM_MDIO=y
CONFIG_E1000=y
CONFIG_MII=y
CONFIG_FSL_LS_MDIO=y
CONFIG_NVME_PCI=y
CONFIG_PCI=y
CONFIG_PCIE_LAYERSCAPE_RC=y
CONFIG_PCIE_LAYERSCAPE_GEN4=y
CONFIG_DM_RTC=y
CONFIG_RTC_PCF2127=y
CONFIG_DM_SCSI=y
CONFIG_DM_SERIAL=y
CONFIG_PL01X_SERIAL=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_NXP_FSPI=y
CONFIG_TEE=y
CONFIG_OPTEE=y
CONFIG_USB=y
CONFIG_USB_XHCI_HCD=y
CONFIG_USB_XHCI_DWC3=y
CONFIG_USB_MAX_CONTROLLER_COUNT=2
CONFIG_WDT=y
CONFIG_WDT_SBSA=y
CONFIG_EFI_LOADER_BOUNCE_BUFFER=y