mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-13 08:27:23 +00:00
aa5bbfd961
When using cygwin64 "dd (coreutils) 8.26 Packaged by Cygwin (8.26-2)", the last not 512bytes aligned data wat cut off and not burned into SD card. Saying the flash.bin size is 1085608 bytes, not 512bytes aligned. It only burned 1085440 bytes, the leaving 168 bytes were not burnned and cause boot issue. So update README dd command to add "conv=notrunc" Signed-off-by: Peng Fan <peng.fan@nxp.com> |
||
|---|---|---|
| .. | ||
| imximage.cfg | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| mx6ullevk.c | ||
| plugin.S | ||
| README | ||
How to use U-Boot on Freescale MX6ULL 14x14 EVK ---------------------------------------------- - First make sure you have installed the dtc package (device tree compiler): $ sudo apt-get install device-tree-compiler - Build U-Boot for MX6ULL 14x14 EVK: $ make mrproper $ make mx6ull_14x14_evk_defconfig $ make This generates the u-boot-dtb.imx image in the current directory. - Flash the u-boot-dtb.imx image into the micro SD card: $ sudo dd if=u-boot-dtb.imx of=/dev/sdb bs=1K seek=1 conv=notrunc && sync - Jumper settings: SW601: 0 0 1 0 Sw602: 1 0 Where 0 means bottom position and 1 means top position (from the switch label numbers reference). Connect the USB cable between the EVK and the PC for the console. (The USB console connector is the one close the push buttons) Insert the micro SD card in the board, power it up and U-Boot messages should come up. The link for the board: http://www.nxp.com/products/microcontrollers-and- \ processors/arm-processors/i.mx-applications-processors/i.mx-6-processors/ \ i.mx6qp/evaluation-kit-for-the-i.mx-6ull-applications-processor:MCIMX6ULL-EVK