u-boot/board/freescale/imxrt1020-evk
Simon Glass f7ae49fc4f common: Drop log.h from common header
Move this header out of the common header.

Signed-off-by: Simon Glass <sjg@chromium.org>
2020-05-18 21:19:18 -04:00
..
imximage.cfg Add support for i.MXRT1020-EVK board 2020-04-18 14:55:00 +02:00
imxrt1020-evk.c common: Drop log.h from common header 2020-05-18 21:19:18 -04:00
Kconfig Add support for i.MXRT1020-EVK board 2020-04-18 14:55:00 +02:00
MAINTAINERS Add support for i.MXRT1020-EVK board 2020-04-18 14:55:00 +02:00
Makefile Add support for i.MXRT1020-EVK board 2020-04-18 14:55:00 +02:00
README imxrt1020-evk: README: change dd command destination 2020-05-01 19:03:10 +02:00

How to use U-Boot on NXP i.MXRT1020 EVK
-----------------------------------------------

- Build U-Boot for i.MXRT1020 EVK:

$ make mrproper
$ make imxrt1020-evk_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/sdX bs=1k seek=1; sync

- Flash the u-boot.img image into the micro SD card:

sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=128; sync

- Jumper settings:

SW8: 0 1 1 0

where 0 means bottom position and 1 means top position (from the
switch label numbers reference).

- Connect the USB cable between the EVK and the PC for the console.
(The USB console connector is the one close the ethernet connector)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.