u-boot/board/grinn/liteboard
Marcin Niestroj c9e40e65e1 board/liteboard: Add support for liteBoard
liteBoard is a development board which uses liteSOM as its base.

Hardware specification:
 * liteSOM (i.MX6UL, DRAM, eMMC)
 * Ethernet PHY (id 0)
 * USB host (usb_otg1)
 * MicroSD slot (uSDHC1)

Signed-off-by: Marcin Niestroj <m.niestroj@grinn-global.com>
2016-12-16 10:31:13 +01:00
..
board.c board/liteboard: Add support for liteBoard 2016-12-16 10:31:13 +01:00
Kconfig board/liteboard: Add support for liteBoard 2016-12-16 10:31:13 +01:00
MAINTAINERS board/liteboard: Add support for liteBoard 2016-12-16 10:31:13 +01:00
Makefile board/liteboard: Add support for liteBoard 2016-12-16 10:31:13 +01:00
README board/liteboard: Add support for liteBoard 2016-12-16 10:31:13 +01:00

How to use U-Boot on Grinn's liteBoard
--------------------------------------

- Build U-Boot for liteBoard:

$ make mrproper
$ make liteboard_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the micro SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

S1: 0 1 0 1 1 1

where 0 means bottom position and 1 means top position (from the
switch label numbers reference).

- Insert the micro SD card in the board.

- Connect USB cable between liteBoard and the PC for the power and console.

- U-Boot messages should come up.