u-boot/drivers/i2c/sun8i_rsb.c
Samuel Holland 3227c85fe7 i2c: Add a DM_I2C driver for the sun8i RSB controller
This bus controller is used to communicate with an X-Powers AXP PMIC.
Currently, various drivers access PMIC registers through a platform-
specific non-DM "pmic_bus" interface, which depends on the legacy I2C
framework. In order to convert those drivers to use DM_PMIC, this bus
needs a DM_I2C driver.

Refactor the rsb functions to take the base address as a parameter,
and implement both the existing interface (which is still needed in
SPL) and the DM_I2C interface on top of them.

The register for switching between I2C/P2WI/RSB mode is the same across
all PMIC variants, so move that to the common header.

There are only a couple of pairs of hardware/runtime addresses used
across all PMIC variants. So far the code expected only the "primary"
pair, but some PMICs like the AXP305 and AXP805 use the secondary pair,
so add support for that to the DM driver as well.

Signed-off-by: Samuel Holland <samuel@sholland.org>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
2021-10-12 10:19:18 +01:00

281 lines
6.8 KiB
C

// SPDX-License-Identifier: GPL-2.0+
/*
* (C) Copyright 2014 Hans de Goede <hdegoede@redhat.com>
*
* Based on allwinner u-boot sources rsb code which is:
* (C) Copyright 2007-2013
* Allwinner Technology Co., Ltd. <www.allwinnertech.com>
* lixiang <lixiang@allwinnertech.com>
*/
#include <axp_pmic.h>
#include <common.h>
#include <dm.h>
#include <errno.h>
#include <i2c.h>
#include <time.h>
#include <asm/arch/cpu.h>
#include <asm/arch/gpio.h>
#include <asm/arch/prcm.h>
#include <asm/arch/rsb.h>
static int sun8i_rsb_await_trans(struct sunxi_rsb_reg *base)
{
unsigned long tmo = timer_get_us() + 1000000;
u32 stat;
int ret;
while (1) {
stat = readl(&base->stat);
if (stat & RSB_STAT_LBSY_INT) {
ret = -EBUSY;
break;
}
if (stat & RSB_STAT_TERR_INT) {
ret = -EIO;
break;
}
if (stat & RSB_STAT_TOVER_INT) {
ret = 0;
break;
}
if (timer_get_us() > tmo) {
ret = -ETIME;
break;
}
}
writel(stat, &base->stat); /* Clear status bits */
return ret;
}
static int sun8i_rsb_do_trans(struct sunxi_rsb_reg *base)
{
setbits_le32(&base->ctrl, RSB_CTRL_START_TRANS);
return sun8i_rsb_await_trans(base);
}
static int sun8i_rsb_read(struct sunxi_rsb_reg *base, u16 runtime_addr,
u8 reg_addr, u8 *data)
{
int ret;
writel(RSB_DEVADDR_RUNTIME_ADDR(runtime_addr), &base->devaddr);
writel(reg_addr, &base->addr);
writel(RSB_CMD_BYTE_READ, &base->cmd);
ret = sun8i_rsb_do_trans(base);
if (ret)
return ret;
*data = readl(&base->data) & 0xff;
return 0;
}
static int sun8i_rsb_write(struct sunxi_rsb_reg *base, u16 runtime_addr,
u8 reg_addr, u8 data)
{
writel(RSB_DEVADDR_RUNTIME_ADDR(runtime_addr), &base->devaddr);
writel(reg_addr, &base->addr);
writel(data, &base->data);
writel(RSB_CMD_BYTE_WRITE, &base->cmd);
return sun8i_rsb_do_trans(base);
}
static int sun8i_rsb_set_device_address(struct sunxi_rsb_reg *base,
u16 device_addr, u16 runtime_addr)
{
writel(RSB_DEVADDR_RUNTIME_ADDR(runtime_addr) |
RSB_DEVADDR_DEVICE_ADDR(device_addr), &base->devaddr);
writel(RSB_CMD_SET_RTSADDR, &base->cmd);
return sun8i_rsb_do_trans(base);
}
static void sun8i_rsb_cfg_io(void)
{
#ifdef CONFIG_MACH_SUN8I
sunxi_gpio_set_cfgpin(SUNXI_GPL(0), SUN8I_GPL_R_RSB);
sunxi_gpio_set_cfgpin(SUNXI_GPL(1), SUN8I_GPL_R_RSB);
sunxi_gpio_set_pull(SUNXI_GPL(0), 1);
sunxi_gpio_set_pull(SUNXI_GPL(1), 1);
sunxi_gpio_set_drv(SUNXI_GPL(0), 2);
sunxi_gpio_set_drv(SUNXI_GPL(1), 2);
#elif defined CONFIG_MACH_SUN9I
sunxi_gpio_set_cfgpin(SUNXI_GPN(0), SUN9I_GPN_R_RSB);
sunxi_gpio_set_cfgpin(SUNXI_GPN(1), SUN9I_GPN_R_RSB);
sunxi_gpio_set_pull(SUNXI_GPN(0), 1);
sunxi_gpio_set_pull(SUNXI_GPN(1), 1);
sunxi_gpio_set_drv(SUNXI_GPN(0), 2);
sunxi_gpio_set_drv(SUNXI_GPN(1), 2);
#else
#error unsupported MACH_SUNXI
#endif
}
static void sun8i_rsb_set_clk(struct sunxi_rsb_reg *base)
{
u32 div = 0;
u32 cd_odly = 0;
/* Source is Hosc24M, set RSB clk to 3Mhz */
div = 24000000 / 3000000 / 2 - 1;
cd_odly = div >> 1;
if (!cd_odly)
cd_odly = 1;
writel((cd_odly << 8) | div, &base->ccr);
}
static int sun8i_rsb_set_device_mode(struct sunxi_rsb_reg *base)
{
unsigned long tmo = timer_get_us() + 1000000;
writel(RSB_DMCR_DEVICE_MODE_START | RSB_DMCR_DEVICE_MODE_DATA,
&base->dmcr);
while (readl(&base->dmcr) & RSB_DMCR_DEVICE_MODE_START) {
if (timer_get_us() > tmo)
return -ETIME;
}
return sun8i_rsb_await_trans(base);
}
static int sun8i_rsb_init(struct sunxi_rsb_reg *base)
{
/* Enable RSB and PIO clk, and de-assert their resets */
prcm_apb0_enable(PRCM_APB0_GATE_PIO | PRCM_APB0_GATE_RSB);
/* Setup external pins */
sun8i_rsb_cfg_io();
writel(RSB_CTRL_SOFT_RST, &base->ctrl);
sun8i_rsb_set_clk(base);
return sun8i_rsb_set_device_mode(base);
}
#if IS_ENABLED(CONFIG_AXP_PMIC_BUS)
int rsb_read(const u16 runtime_addr, const u8 reg_addr, u8 *data)
{
struct sunxi_rsb_reg *base = (struct sunxi_rsb_reg *)SUNXI_RSB_BASE;
return sun8i_rsb_read(base, runtime_addr, reg_addr, data);
}
int rsb_write(const u16 runtime_addr, const u8 reg_addr, u8 data)
{
struct sunxi_rsb_reg *base = (struct sunxi_rsb_reg *)SUNXI_RSB_BASE;
return sun8i_rsb_write(base, runtime_addr, reg_addr, data);
}
int rsb_set_device_address(u16 device_addr, u16 runtime_addr)
{
struct sunxi_rsb_reg *base = (struct sunxi_rsb_reg *)SUNXI_RSB_BASE;
return sun8i_rsb_set_device_address(base, device_addr, runtime_addr);
}
int rsb_init(void)
{
struct sunxi_rsb_reg *base = (struct sunxi_rsb_reg *)SUNXI_RSB_BASE;
return sun8i_rsb_init(base);
}
#endif
#if CONFIG_IS_ENABLED(DM_I2C)
struct sun8i_rsb_priv {
struct sunxi_rsb_reg *base;
};
/*
* The mapping from hardware address to runtime address is fixed, and shared
* among all RSB drivers. See the comment in drivers/bus/sunxi-rsb.c in Linux.
*/
static int sun8i_rsb_get_runtime_address(u16 device_addr)
{
if (device_addr == AXP_PMIC_PRI_DEVICE_ADDR)
return AXP_PMIC_PRI_RUNTIME_ADDR;
if (device_addr == AXP_PMIC_SEC_DEVICE_ADDR)
return AXP_PMIC_SEC_RUNTIME_ADDR;
return -ENXIO;
}
static int sun8i_rsb_xfer(struct udevice *bus, struct i2c_msg *msg, int nmsgs)
{
int runtime_addr = sun8i_rsb_get_runtime_address(msg->addr);
struct sun8i_rsb_priv *priv = dev_get_priv(bus);
if (runtime_addr < 0)
return runtime_addr;
/* The hardware only supports SMBus-style transfers. */
if (nmsgs == 2 && msg[1].flags == I2C_M_RD && msg[1].len == 1)
return sun8i_rsb_read(priv->base, runtime_addr,
msg[0].buf[0], &msg[1].buf[0]);
if (nmsgs == 1 && msg[0].len == 2)
return sun8i_rsb_write(priv->base, runtime_addr,
msg[0].buf[0], msg[0].buf[1]);
return -EINVAL;
}
static int sun8i_rsb_probe_chip(struct udevice *bus, uint chip_addr,
uint chip_flags)
{
int runtime_addr = sun8i_rsb_get_runtime_address(chip_addr);
struct sun8i_rsb_priv *priv = dev_get_priv(bus);
if (runtime_addr < 0)
return runtime_addr;
return sun8i_rsb_set_device_address(priv->base, chip_addr, runtime_addr);
}
static int sun8i_rsb_probe(struct udevice *bus)
{
struct sun8i_rsb_priv *priv = dev_get_priv(bus);
priv->base = dev_read_addr_ptr(bus);
return sun8i_rsb_init(priv->base);
}
static int sun8i_rsb_child_pre_probe(struct udevice *child)
{
struct dm_i2c_chip *chip = dev_get_parent_plat(child);
/* Ensure each transfer is for a single register. */
chip->flags |= DM_I2C_CHIP_RD_ADDRESS | DM_I2C_CHIP_WR_ADDRESS;
return 0;
}
static const struct dm_i2c_ops sun8i_rsb_ops = {
.xfer = sun8i_rsb_xfer,
.probe_chip = sun8i_rsb_probe_chip,
};
static const struct udevice_id sun8i_rsb_ids[] = {
{ .compatible = "allwinner,sun8i-a23-rsb" },
{ /* sentinel */ }
};
U_BOOT_DRIVER(sun8i_rsb) = {
.name = "sun8i_rsb",
.id = UCLASS_I2C,
.of_match = sun8i_rsb_ids,
.probe = sun8i_rsb_probe,
.child_pre_probe = sun8i_rsb_child_pre_probe,
.priv_auto = sizeof(struct sun8i_rsb_priv),
.ops = &sun8i_rsb_ops,
};
#endif /* CONFIG_IS_ENABLED(DM_I2C) */