u-boot/board/freescale/mx6ullevk
Stefano Babic d714a75fd4 imx: replace CONFIG_SECURE_BOOT with CONFIG_IMX_HAB
CONFIG_SECURE_BOOT is too generic and forbids to use it for cross
architecture purposes. If Secure Boot is required for imx, this means to
enable and use the HAB processor in the soc.

Signed-off-by: Stefano Babic <sbabic@denx.de>
2019-10-08 16:36:37 +02:00
..
imximage.cfg imx: replace CONFIG_SECURE_BOOT with CONFIG_IMX_HAB 2019-10-08 16:36:37 +02:00
Kconfig arm: imx: add i.MX6ULL 14x14 EVK board support 2016-10-04 15:42:07 +02:00
MAINTAINERS imx: add i.MX6ULZ board 2019-10-08 16:33:45 +02:00
Makefile SPDX: Convert all of our single license tags to Linux Kernel style 2018-05-07 09:34:12 -04:00
mx6ullevk.c imx: add i.MX6ULZ board 2019-10-08 16:33:45 +02:00
plugin.S SPDX: Convert all of our single license tags to Linux Kernel style 2018-05-07 09:34:12 -04:00
README mx6ull_14x14_evk: Add README file 2016-11-13 15:54:35 -05:00

How to use U-Boot on Freescale MX6ULL 14x14 EVK
----------------------------------------------

- First make sure you have installed the dtc package (device tree compiler):

$ sudo apt-get install device-tree-compiler

- Build U-Boot for MX6ULL 14x14 EVK:

$ make mrproper
$ make mx6ull_14x14_evk_defconfig
$ make

This generates the u-boot-dtb.imx image in the current directory.

- Flash the u-boot-dtb.imx image into the micro SD card:

$ sudo dd if=u-boot-dtb.imx of=/dev/sdb bs=1K seek=1 && sync

- Jumper settings:

SW601: 0 0 1 0
Sw602: 1 0

Where 0 means bottom position and 1 means top position (from the switch label
numbers reference).

Connect the USB cable between the EVK and the PC for the console.
(The USB console connector is the one close the push buttons)

Insert the micro SD card in the board, power it up and U-Boot messages should
come up.

The link for the board: http://www.nxp.com/products/microcontrollers-and- \
processors/arm-processors/i.mx-applications-processors/i.mx-6-processors/ \
i.mx6qp/evaluation-kit-for-the-i.mx-6ull-applications-processor:MCIMX6ULL-EVK