mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-05 20:54:31 +00:00
401d1c4f5d
Move this out of the common header and include it only where needed. In a number of cases this requires adding "struct udevice;" to avoid adding another large header or in other cases replacing / adding missing header files that had been pulled in, very indirectly. Finally, we have a few cases where we did not need to include <asm/global_data.h> at all, so remove that include. Signed-off-by: Simon Glass <sjg@chromium.org> Signed-off-by: Tom Rini <trini@konsulko.com> |
||
|---|---|---|
| .. | ||
| dart_6ul.c | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
| spl.c | ||
How to use U-Boot on variscite DART-6UL Evaluation Kit
------------------------------------------------------
- Configure and build U-Boot for DART-6UL iMX6ULL:
$ make mrproper
$ make variscite_dart6ul_defconfig
$ make
This will generate SPL and u-boot-dtb.img images.
Boot from MMC/SD:
- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:
$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
- Boot mode settings:
Boot switch position: SW1 -> 0
SW2 -> 0
Boot from eMMC:
- if bootpart is not enabled by default, to enable under Linux
echo 0 >/sys/block/mmcblk1boot0/force_ro
mmc bootpart enable 1 1 /dev/mmcblk1boot0
- Flash the SPL and u-boot-dtb.img to mmcblk1boot0
$ sudo dd if=SPL of=/dev/mmcblk1boot0 bs=1k seek=1; sync
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk1boot0 bs=1k seek=69; sync
- Boot mode settings:
Boot switch position: SW1 -> 0
SW2 -> 1
- Connect the Serial cable to UART0 and the PC for the console.
- Insert the micro SD card in the board and power it up.
- U-Boot messages should come up.