mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-12-22 19:23:07 +00:00
06ddcfc95a
This value is only referenced by PowerPC code in a way other than directly as CONFIG_SYS_INIT_SP_ADDR. Switch to CONFIG_SYS_INIT_SP_ADDR directly. Signed-off-by: Tom Rini <trini@konsulko.com>
156 lines
4.8 KiB
C
156 lines
4.8 KiB
C
/* SPDX-License-Identifier: GPL-2.0+ */
|
|
/*
|
|
* Configuation settings for the Freescale MCF5329 FireEngine board.
|
|
*
|
|
* Copyright (C) 2004-2007 Freescale Semiconductor, Inc.
|
|
* TsiChung Liew (Tsi-Chung.Liew@freescale.com)
|
|
*/
|
|
|
|
/*
|
|
* board/config.h - configuration options, board specific
|
|
*/
|
|
|
|
#ifndef _M5235EVB_H
|
|
#define _M5235EVB_H
|
|
|
|
/*
|
|
* High Level Configuration Options
|
|
* (easy to change)
|
|
*/
|
|
|
|
#define CONFIG_SYS_UART_PORT (0)
|
|
|
|
#define CONFIG_WATCHDOG_TIMEOUT 5000 /* timeout in milliseconds, max timeout is 6.71sec */
|
|
|
|
#ifdef CONFIG_MCFFEC
|
|
# define CONFIG_SYS_DISCOVER_PHY
|
|
/* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
|
|
# ifndef CONFIG_SYS_DISCOVER_PHY
|
|
# define FECDUPLEX FULL
|
|
# define FECSPEED _100BASET
|
|
# endif /* CONFIG_SYS_DISCOVER_PHY */
|
|
#endif
|
|
|
|
/* I2C */
|
|
#define CONFIG_SYS_I2C_PINMUX_REG (gpio->par_qspi)
|
|
#define CONFIG_SYS_I2C_PINMUX_CLR ~(GPIO_PAR_FECI2C_SCL_MASK | GPIO_PAR_FECI2C_SDA_MASK)
|
|
#define CONFIG_SYS_I2C_PINMUX_SET (GPIO_PAR_FECI2C_SCL_I2CSCL | GPIO_PAR_FECI2C_SDA_I2CSDA)
|
|
|
|
/* this must be included AFTER the definition of CONFIG COMMANDS (if any) */
|
|
#ifdef CONFIG_MCFFEC
|
|
# define CONFIG_IPADDR 192.162.1.2
|
|
# define CONFIG_NETMASK 255.255.255.0
|
|
# define CONFIG_SERVERIP 192.162.1.1
|
|
# define CONFIG_GATEWAYIP 192.162.1.1
|
|
#endif /* FEC_ENET */
|
|
|
|
#define CONFIG_HOSTNAME "M5235EVB"
|
|
#define CONFIG_EXTRA_ENV_SETTINGS \
|
|
"netdev=eth0\0" \
|
|
"loadaddr=10000\0" \
|
|
"u-boot=u-boot.bin\0" \
|
|
"load=tftp ${loadaddr) ${u-boot}\0" \
|
|
"upd=run load; run prog\0" \
|
|
"prog=prot off ffe00000 ffe3ffff;" \
|
|
"era ffe00000 ffe3ffff;" \
|
|
"cp.b ${loadaddr} ffe00000 ${filesize};"\
|
|
"save\0" \
|
|
""
|
|
|
|
#define CONFIG_PRAM 512 /* 512 KB */
|
|
|
|
#define CONFIG_SYS_CLK 75000000
|
|
#define CONFIG_SYS_CPU_CLK CONFIG_SYS_CLK * 2
|
|
|
|
#define CONFIG_SYS_MBAR 0x40000000
|
|
|
|
/*
|
|
* Low Level Configuration Settings
|
|
* (address mappings, register initial values, etc.)
|
|
* You should know what you are doing if you make changes here.
|
|
*/
|
|
/*-----------------------------------------------------------------------
|
|
* Definitions for initial stack pointer and data area (in DPRAM)
|
|
*/
|
|
#define CONFIG_SYS_INIT_RAM_ADDR 0x20000000
|
|
#define CONFIG_SYS_INIT_RAM_SIZE 0x10000 /* Size of used area in internal SRAM */
|
|
#define CONFIG_SYS_INIT_RAM_CTRL 0x21
|
|
#define CONFIG_SYS_INIT_SP_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE - 0x10)
|
|
|
|
/*-----------------------------------------------------------------------
|
|
* Start addresses for the final memory configuration
|
|
* (Set up by the startup code)
|
|
* Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
|
|
*/
|
|
#define CONFIG_SYS_SDRAM_BASE 0x00000000
|
|
#define CONFIG_SYS_SDRAM_SIZE 16 /* SDRAM size in MB */
|
|
|
|
#define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */
|
|
|
|
/*
|
|
* For booting Linux, the board info and command line data
|
|
* have to be in the first 8 MB of memory, since this is
|
|
* the maximum mapped by the Linux kernel during initialization ??
|
|
*/
|
|
/* Initial Memory map for Linux */
|
|
#define CONFIG_SYS_BOOTMAPSZ (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
|
|
#define CONFIG_SYS_BOOTM_LEN (CONFIG_SYS_SDRAM_SIZE << 20)
|
|
|
|
/*-----------------------------------------------------------------------
|
|
* FLASH organization
|
|
*/
|
|
#ifdef CONFIG_SYS_FLASH_CFI
|
|
# define CONFIG_SYS_FLASH_SIZE 0x800000 /* Max size that the board might have */
|
|
# define CONFIG_SYS_MAX_FLASH_SECT 137 /* max number of sectors on one chip */
|
|
#endif
|
|
|
|
#define CONFIG_SYS_FLASH_BASE (CONFIG_SYS_CS0_BASE)
|
|
|
|
/* Configuration for environment
|
|
* Environment is embedded in u-boot in the second sector of the flash
|
|
*/
|
|
|
|
#define LDS_BOARD_TEXT \
|
|
. = DEFINED(env_offset) ? env_offset : .; \
|
|
env/embedded.o(.text);
|
|
|
|
/*-----------------------------------------------------------------------
|
|
* Cache Configuration
|
|
*/
|
|
|
|
#define ICACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \
|
|
CONFIG_SYS_INIT_RAM_SIZE - 8)
|
|
#define DCACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \
|
|
CONFIG_SYS_INIT_RAM_SIZE - 4)
|
|
#define CONFIG_SYS_ICACHE_INV (CF_CACR_CINV)
|
|
#define CONFIG_SYS_CACHE_ACR0 (CONFIG_SYS_SDRAM_BASE | \
|
|
CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
|
|
CF_ACR_EN | CF_ACR_SM_ALL)
|
|
#define CONFIG_SYS_CACHE_ICACR (CF_CACR_CENB | CF_CACR_DISD | \
|
|
CF_CACR_CEIB | CF_CACR_DCM | \
|
|
CF_CACR_EUSP)
|
|
|
|
/*-----------------------------------------------------------------------
|
|
* Chipselect bank definitions
|
|
*/
|
|
/*
|
|
* CS0 - NOR Flash 1, 2, 4, or 8MB
|
|
* CS1 - Available
|
|
* CS2 - Available
|
|
* CS3 - Available
|
|
* CS4 - Available
|
|
* CS5 - Available
|
|
* CS6 - Available
|
|
* CS7 - Available
|
|
*/
|
|
#ifdef CONFIG_NORFLASH_PS32BIT
|
|
# define CONFIG_SYS_CS0_BASE 0xFFC00000
|
|
# define CONFIG_SYS_CS0_MASK 0x003f0001
|
|
# define CONFIG_SYS_CS0_CTRL 0x00001D00
|
|
#else
|
|
# define CONFIG_SYS_CS0_BASE 0xFFE00000
|
|
# define CONFIG_SYS_CS0_MASK 0x001f0001
|
|
# define CONFIG_SYS_CS0_CTRL 0x00001D80
|
|
#endif
|
|
|
|
#endif /* _M5329EVB_H */
|