u-boot/board/phytec/pcl063
Parthiban Nallathambi 921bb8641d imx: initialize fec only when enabled
board early initialize fec ethernet controller pinmux
only when FEC is enabled

Signed-off-by: Parthiban Nallathambi <pn@denx.de>
Reviewed-by: Peng Fan <peng.fan@nxp.com>
2019-10-08 16:36:37 +02:00
..
Kconfig imx: Extend PCL063 support for phyCORE-i.MX6ULL SOM 2019-06-11 10:42:48 +02:00
MAINTAINERS imx: Extend PCL063 support for phyCORE-i.MX6ULL SOM 2019-06-11 10:42:48 +02:00
Makefile imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
pcl063.c imx: initialize fec only when enabled 2019-10-08 16:36:37 +02:00
README imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
spl.c imx: remove board specific boot order from spl 2019-10-08 16:36:37 +02:00

How to use U-Boot on PHYTEC phyBOARD-i.MX6UL-Segin
--------------------------------------------------

- Configure and build U-Boot for phyCORE-i.MX6UL:

    $ make mrproper
    $ make phycore_pcl063_defconfig
    $ make

  This will generate SPL and u-boot-dtb.img images.

- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:

    $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
    $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

  JP1:   Open: Boot from NAND
       Closed: Boot from SD/MMC1

- Connect the Serial cable to UART0 and the PC for the console.

- Insert the micro SD card in the board and power it up.

- U-Boot messages should come up.