2
0
Fork 0
mirror of https://github.com/AsahiLinux/u-boot synced 2024-12-26 04:53:42 +00:00
u-boot/board/solidrun/clearfog/README
Baruch Siach e6a5a5c72b arm: mvebu: clearfog: update eMMC documentation
SPL now automatically selects the correct U-Boot image offset for both
eMMC and SD card. No need to tweak
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR anymore.

Signed-off-by: Baruch Siach <baruch@tkos.co.il>
Reviewed-by: Stefan Roese <sr@denx.de>
Signed-off-by: Stefan Roese <sr@denx.de>
2020-01-16 10:59:14 +01:00

74 lines
2 KiB
Text

Update from original Marvell U-Boot to mainline U-Boot:
-------------------------------------------------------
Generate the U-Boot image with these commands:
$ make clearfog_defconfig
$ make
The resulting image including the SPL binary with the
full DDR setup is "u-boot-spl.kwb".
Now all you need to do is copy this image on a SD card.
For example with this command:
$ sudo dd if=u-boot-spl.kwb of=/dev/sdX bs=512 seek=1
Please use the correct device node for your setup instead
of "/dev/sdX" here!
Install U-Boot on eMMC:
-----------------------
To make SPL load the main U-Boot image from the eMMC boot partition enable
eMMC boot acknowledgement and boot partition with the following U-Boot
command:
mmc partconf 0 1 1 0
Install U-Boot on eMMC boot partition from Linux running on Clearfog:
echo 0 > /sys/block/mmcblk0boot0/force_ro
dd if=u-boot-spl.kwb of=/dev/mmcblk0boot0
Note that the SD card is not accessible when the Clearfog SOM has eMMC.
Consider initial boot from UART (see below).
Install U-Boot on SATA:
-----------------------
When loading the main U-Boot image from raw SATA sector, set
CONFIG_SPL_SATA_RAW_U_BOOT_SECTOR to 0x141.
Boot selection:
---------------
Before powering up the board, boot selection should be done via the SW1 dip
switch (0: OFF, 1: ON):
- SPI: 00010
- SD/eMMC: 00111
- M.2 SSD: 11100
- UART: 01001 [1]
[1]: According to SolidRun's manual, 11110 should be used for UART booting on
the ClearFog 'Pro' variant.
However, this doesn't work (anymore) at least on Rev. 2.1 (but '01001' as
mentionend for the 'Base' variant does).
Boot from UART:
---------------
Connect the on-board micro-USB (CF Pro: CON11, CF Base: CON5)
to your host.
Set the SW1 DIP switches to UART boot (see above).
Run the following command to initiate U-Boot download:
./tools/kwboot -b u-boot-spl.kwb /dev/ttyUSBX
Use the correct UART device node for /dev/ttyUSBX.
When download finishes start your favorite terminal emulator
on /dev/ttyUSBX.