mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-07 05:34:28 +00:00
367ea426a5
This patch adds support for the Qualcomm QUP SPI controller that is commonly found in most of Qualcomm SoC-s. Driver currently supports v1.1.1, v2.1.1 and v2.2.1 HW. FIFO and Block modes are supported, no support for DMA mode is planned. Signed-off-by: Robert Marko <robert.marko@sartura.hr> Signed-off-by: Luka Kovacic <luka.kovacic@sartura.hr> Cc: Luka Perkov <luka.perkov@sartura.hr>
33 lines
1.1 KiB
Text
33 lines
1.1 KiB
Text
Qualcomm QUP SPI controller Device Tree Bindings
|
|
-------------------------------------------
|
|
|
|
Required properties:
|
|
- compatible : Should be "qcom,spi-qup-v1.1.1", "qcom,spi-qup-v2.1.1"
|
|
or "qcom,spi-qup-v2.2.1"
|
|
- reg : Physical base address and size of SPI registers map.
|
|
- clock : Clock phandle (see clock bindings for details).
|
|
- #address-cells : Number of cells required to define a chip select
|
|
address on the SPI bus. Should be set to 1.
|
|
- #size-cells : Should be zero.
|
|
- pinctrl-names : Must be "default"
|
|
- pinctrl-n : At least one pinctrl phandle
|
|
- cs-gpios : Should specify GPIOs used for chipselects.
|
|
The gpios will be referred to as reg = <index> in the
|
|
SPI child nodes.
|
|
|
|
Optional properties:
|
|
- num-cs : total number of chipselects
|
|
|
|
Example:
|
|
|
|
blsp1_spi1: spi@78b5000 {
|
|
compatible = "qcom,spi-qup-v2.2.1";
|
|
reg = <0x78b5000 0x600>;
|
|
clock = <&gcc 23>;
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
pinctrl-names = "spi";
|
|
pinctrl-0 = <&blsp_spi0>;
|
|
num-cs = <2>;
|
|
cs-gpios = <&soc_gpios 54 GPIO_ACTIVE_HIGH>, <&soc_gpios 4 GPIO_ACTIVE_HIGH>;
|
|
};
|