mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-09-21 07:01:57 +00:00
741ce3084e
SoM revision 1.9 has replaced the ar8035 phy address 0 with an adin1300 at address 1. Because early SoMs had a hardware flaw, the ar8035 can also appear at address 4 - making it a total of 3 phy nodes in the DTB. To avoid confusing Linux with probe errors, fixup the dtb to only enable the phy node that is detected at runtime. Signed-off-by: Josua Mayer <josua@solid-run.com> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| mx6cuboxi.c | ||
| README | ||
How to use U-Boot on Solid-run mx6 Hummingboard and Cubox-i ----------------------------------------------------------- - Build U-Boot for Hummingboard/Cubox-i: $ make mrproper $ make mx6cuboxi_defconfig $ make This will generate the SPL image called SPL and the u-boot.img. - Flash the SPL image into the SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot.img image into the SD card: sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync - Insert the SD card in the board, power it up and U-Boot messages should come up.