mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-09-23 08:01:59 +00:00
392aa4ba96
By default the Model information from DT is printed: CPU: Freescale i.MX6SX rev1.2 996 MHz (running at 792 MHz) CPU: Extended Commercial temperature grade (-20C to 105C) at 63C Reset cause: POR Model: UDOO Neo Basic Board: UDOO Neo FULL I2C: ready As the udoo basic DT is used, such output may be confusing. Improve it by only printing the Board model instead, which is read from the board identification GPIOs. Signed-off-by: Fabio Estevam <festevam@gmail.com> Acked-by: Tommaso Merciai <tomm.merciai@gmail.com> Tested-by: Tommaso Merciai <tomm.merciai@gmail.com> |
||
|---|---|---|
| .. | ||
| neo | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
| udoo.c | ||
| udoo_spl.c | ||
How to use U-Boot on MX6Q/DL Udoo boards ---------------------------------------- - Build U-Boot for MX6Q/DL Udoo boards: $ make mrproper $ make udoo_defconfig $ make This will generate the SPL image called SPL and the u-boot.img. - Flash the SPL image into the SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot.img image into the SD card: sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync - Insert the SD card in the board, power it up and U-Boot messages should come up.