u-boot/configs/Nintendo_NES_Classic_Edition_defconfig
Samuel Holland 7d5b17cca6 sunxi: Switch to PMIC USB power supply VBUS detection
Update boards to use the USB power supply driver, as referenced in the
device tree, instead of a virtual GPIO. This removes the need for some
DM-incompatible special cases in the GPIO driver.

The following five boards used AXP0-VBUS-DETECT in their config, but are
missing the "usb0_vbus_power-supply" property in their device tree:
 - Ainol_AW1_defconfig / sun7i-a20-ainol-aw1
 - Cubieboard4_defconfig / sun9i-a80-cubieboard4
 - Merrii_A80_Optimus_defconfig / sun9i-a80-optimus
 - Yones_Toptech_BD1078_defconfig / sun7i-a20-yones-toptech-bd1078
 - Yones_Toptech_BS1078_V2_defconfig /
   sun6i-a31s-yones-toptech-bs1078-v2

None of those five boards have the MUSB controller (USB OTG) enabled in
their device trees, so this change should not break anything for them.

Additionally, the following board intentionally omits the property
because VBUS is always enabled:
 - Nintendo_NES_Classic_Edition_defconfig /
   sun8i-r16-nintendo-nes-classic

The PHY driver already assumes VBUS is enabled when no detection method
is available, so again this will not cause any problems.

Signed-off-by: Samuel Holland <samuel@sholland.org>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
2023-04-28 01:30:05 +01:00

27 lines
723 B
Text

CONFIG_ARM=y
CONFIG_ARCH_SUNXI=y
CONFIG_DEFAULT_DEVICE_TREE="sun8i-r16-nintendo-nes-classic"
CONFIG_SPL=y
CONFIG_MACH_SUN8I_A33=y
CONFIG_DRAM_CLK=600
CONFIG_DRAM_ZQ=15291
CONFIG_DRAM_ODT_EN=y
CONFIG_AXP_GPIO=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_MTDPARTS=y
# CONFIG_MMC is not set
CONFIG_MTD=y
CONFIG_MTD_RAW_NAND=y
CONFIG_SYS_MAX_NAND_DEVICE=8
CONFIG_SYS_NAND_BLOCK_SIZE=0x20000
CONFIG_SYS_NAND_ONFI_DETECTION=y
CONFIG_SYS_NAND_PAGE_SIZE=0x800
CONFIG_SYS_NAND_OOBSIZE=0x40
CONFIG_SYS_NAND_MAX_ECCPOS=1664
CONFIG_REGULATOR_AXP_USB_POWER=y
CONFIG_AXP_DLDO1_VOLT=3300
CONFIG_AXP_ELDO2_VOLT=1800
CONFIG_CONS_INDEX=5
CONFIG_USB_MUSB_GADGET=y
CONFIG_USB_FUNCTION_MASS_STORAGE=y