u-boot/configs/MPC8313ERDB_NAND_66_defconfig
Mario Six 21c1502a4a mpc83xx: Kconfig: Migrate HRCW to Kconfig
The HRCW (hardware reset configuration word) is a constant that must be
hard-coded into the boot loader image. So, it must be available at
compile time, and cannot be migrated to the DT mechanism, but has to be
kept in Kconfig.

Configuration of this crucial variable should still be somewhat
comfortable. Hence, make its fields configurable in Kconfig, and
assemble the final value from these.

Signed-off-by: Mario Six <mario.six@gdsys.cc>
2019-05-21 07:52:25 +02:00

49 lines
1.3 KiB
Text

CONFIG_PPC=y
CONFIG_SYS_TEXT_BASE=0x00100000
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL=y
CONFIG_SYS_CLK_FREQ=66666667
CONFIG_MPC83xx=y
CONFIG_TARGET_MPC8313ERDB_NAND=y
CONFIG_CORE_PLL_RATIO_2_1=y
CONFIG_PCI_HOST_MODE_ENABLE=y
CONFIG_PCI_INT_ARBITER1_ENABLE=y
CONFIG_BOOT_ROM_INTERFACE_NAND_FLASH_8BIT_SMALL=y
CONFIG_TSEC1_MODE_RGMII=y
CONFIG_TSEC2_MODE_RGMII=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_SYS_EXTRA_OPTIONS="SYS_66MHZ"
CONFIG_BOOTDELAY=6
CONFIG_MISC_INIT_R=y
CONFIG_BOARD_EARLY_INIT_R=y
# CONFIG_SPL_FRAMEWORK is not set
CONFIG_SPL_TEXT_BASE=0xFFF00000
CONFIG_SPL_NAND_SUPPORT=y
CONFIG_HUSH_PARSER=y
CONFIG_CMD_IMLS=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_NAND=y
CONFIG_CMD_PCI=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DHCP=y
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_DATE=y
CONFIG_CMD_MTDPARTS=y
CONFIG_MTDIDS_DEFAULT="nand0=e2800000.flash"
CONFIG_MTDPARTS_DEFAULT="mtdparts=e2800000.flash:512k(uboot),128k(env),6m@1m(kernel),-(fs)"
# CONFIG_ENV_IS_IN_FLASH is not set
CONFIG_ENV_IS_IN_NAND=y
# CONFIG_MMC is not set
CONFIG_MTD_NOR_FLASH=y
CONFIG_FLASH_CFI_DRIVER=y
CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
CONFIG_SYS_FLASH_PROTECTION=y
CONFIG_SYS_FLASH_CFI=y
CONFIG_NAND=y
CONFIG_PHY_MARVELL=y
CONFIG_TSEC_ENET=y
CONFIG_SYS_NS16550=y
CONFIG_OF_LIBFDT=y