mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-24 21:54:01 +00:00
c280ec210f
Calling gpio_request() prior to its usage is now mandatory. This fixes the following GPIO errors: U-Boot SPL 2022.01-rc3-00067-g7a5be871c0ec (Dec 18 2021 - 17:45:07 -0300) Trying to boot from MMC1 U-Boot 2022.01-rc3-00067-g7a5be871c0ec (Dec 18 2021 - 17:45:07 -0300) CPU: Freescale i.MX6Q rev1.2 at 792 MHz Reset cause: WDOG Model: Udoo i.MX6 Quad Board Board: Udoo Quad DRAM: 1 GiB MMC: FSL_SDHC: 2 Loading Environment from MMC... OK In: serial Out: serial Err: serial gpio@20a0000: set_dir_flags: error: gpio GPIO2_31 not reserved gpio@20a4000: set_dir_flags: error: gpio GPIO3_23 not reserved gpio@20b0000: set_dir_flags: error: gpio GPIO6_24 not reserved gpio@20b0000: set_dir_flags: error: gpio GPIO6_25 not reserved gpio@20b0000: set_dir_flags: error: gpio GPIO6_27 not reserved gpio@20b0000: set_dir_flags: error: gpio GPIO6_28 not reserved gpio@20b0000: set_dir_flags: error: gpio GPIO6_29 not reserved gpio@20a4000: set_value: error: gpio GPIO3_23 not reserved Net: Could not get PHY for FEC0: addr -2 No ethernet found. Signed-off-by: Fabio Estevam <festevam@gmail.com> Reviewed-by: Peter Robinson <pbrobinson@gmail.com> |
||
|---|---|---|
| .. | ||
| neo | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
| udoo.c | ||
| udoo_spl.c | ||
How to use U-Boot on MX6Q/DL Udoo boards ---------------------------------------- - Build U-Boot for MX6Q/DL Udoo boards: $ make mrproper $ make udoo_defconfig $ make This will generate the SPL image called SPL and the u-boot.img. - Flash the SPL image into the SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot.img image into the SD card: sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync - Insert the SD card in the board, power it up and U-Boot messages should come up.