u-boot/include/configs/armadillo-800eva.h
Tom Rini a09fea1d28 env: Finish migration of common ENV options
- In ARMv8 NXP Layerscape platforms we also need to make use of
  CONFIG_SYS_RELOC_GD_ENV_ADDR now, do so.
- On ENV_IS_IN_REMOTE, CONFIG_ENV_OFFSET is never used, drop the define
  to 0.
- Add Kconfig entry for ENV_ADDR.
- Make ENV_ADDR / ENV_OFFSET depend on the env locations that use it.
- Add ENV_xxx_REDUND options that depend on their primary option and
  SYS_REDUNDAND_ENVIRONMENT
- On a number of PowerPC platforms, use SPL_ENV_ADDR not CONFIG_ENV_ADDR
  for the pre-main-U-Boot environment location.
- On ENV_IS_IN_SPI_FLASH, check not for CONFIG_ENV_ADDR being set but
  rather it being non-zero, as it will now be zero by default.
- Rework the env_offset absolute in env/embedded.o to not use
  CONFIG_ENV_OFFSET as it was the only use of ENV_OFFSET within
  ENV_IS_IN_FLASH.
- Migrate all platforms.

Cc: Wolfgang Denk <wd@denx.de>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Patrick Delaunay <patrick.delaunay@st.com>
Cc: uboot-stm32@st-md-mailman.stormreply.com
Signed-off-by: Tom Rini <trini@konsulko.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Reviewed-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
2019-11-20 18:32:09 -05:00

88 lines
2.5 KiB
C

/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Configuation settings for the bonito board
*
* Copyright (C) 2012 Renesas Solutions Corp.
*/
#ifndef __ARMADILLO_800EVA_H
#define __ARMADILLO_800EVA_H
#define CONFIG_SH_GPIO_PFC
#include <asm/arch/rmobile.h>
#define BOARD_LATE_INIT
#define CONFIG_TMU_TIMER
#define CONFIG_SYS_TIMER_COUNTS_DOWN
#define CONFIG_SYS_TIMER_COUNTER (TMU_BASE + 0xc) /* TCNT0 */
#define CONFIG_SYS_TIMER_RATE (CONFIG_SYS_CLK_FREQ / 4)
/* STACK */
#define CONFIG_SYS_INIT_SP_ADDR 0xE8083000
#define STACK_AREA_SIZE 0xC000
#define LOW_LEVEL_MERAM_STACK \
(CONFIG_SYS_INIT_SP_ADDR + STACK_AREA_SIZE - 4)
/* MEMORY */
#define ARMADILLO_800EVA_SDRAM_BASE 0x40000000
#define ARMADILLO_800EVA_SDRAM_SIZE (512 * 1024 * 1024)
#define CONFIG_SYS_PBSIZE 256
#define CONFIG_SYS_BAUDRATE_TABLE { 115200 }
/* SCIF */
#define CONFIG_CONS_SCIF1
#define SCIF0_BASE 0xe6c40000
#define SCIF1_BASE 0xe6c50000
#define SCIF2_BASE 0xe6c60000
#define SCIF4_BASE 0xe6c80000
#define CONFIG_SCIF_A
#define CONFIG_SYS_MEMTEST_START (ARMADILLO_800EVA_SDRAM_BASE)
#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + \
504 * 1024 * 1024)
#undef CONFIG_SYS_MEMTEST_SCRATCH
#undef CONFIG_SYS_LOADS_BAUD_CHANGE
#define CONFIG_SYS_SDRAM_BASE (ARMADILLO_800EVA_SDRAM_BASE)
#define CONFIG_SYS_SDRAM_SIZE (ARMADILLO_800EVA_SDRAM_SIZE)
#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + \
64 * 1024 * 1024)
#define CONFIG_SYS_MONITOR_BASE 0x00000000
#define CONFIG_SYS_MONITOR_LEN (256 * 1024)
#define CONFIG_SYS_MALLOC_LEN (1 * 1024 * 1024)
#define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024)
/* FLASH */
#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT
#define CONFIG_SYS_FLASH_BASE 0x00000000
#define CONFIG_SYS_MAX_FLASH_SECT 512
#define CONFIG_SYS_MAX_FLASH_BANKS 1
#define CONFIG_SYS_FLASH_BANKS_LIST { (CONFIG_SYS_FLASH_BASE) }
#define CONFIG_SYS_FLASH_ERASE_TOUT 3000
#define CONFIG_SYS_FLASH_WRITE_TOUT 3000
#define CONFIG_SYS_FLASH_LOCK_TOUT 3000
#define CONFIG_SYS_FLASH_UNLOCK_TOUT 3000
/* ENV setting */
#define CONFIG_ENV_OVERWRITE 1
/* SH Ether */
#define CONFIG_SH_ETHER_USE_PORT 0
#define CONFIG_SH_ETHER_PHY_ADDR 0x0
#define CONFIG_SH_ETHER_BASE_ADDR 0xe9a00000
#define CONFIG_SH_ETHER_SH7734_MII (0x01)
#define CONFIG_SH_ETHER_PHY_MODE PHY_INTERFACE_MODE_MII
#define CONFIG_PHY_SMSC
#define CONFIG_BITBANGMII
#define CONFIG_BITBANGMII_MULTI
/* Board Clock */
#define CONFIG_SYS_CLK_FREQ 50000000
#define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ
#endif /* __ARMADILLO_800EVA_H */