u-boot/board/wandboard
Anatolij Gustschin 2cbf1b3215 imx6: wandboard: convert to DM_MMC
Move SDHC init to SPL code since it is not required with
DM_MMC. Enable DM_MMC support.

Signed-off-by: Anatolij Gustschin <agust@denx.de>
2019-04-13 20:30:09 +02:00
..
Kconfig mx6: remove SYS_SOC from board Kconfig 2015-09-13 10:37:29 +02:00
MAINTAINERS imx6: wandboard: add device tree 2019-04-13 20:30:09 +02:00
Makefile SPDX: Convert all of our single license tags to Linux Kernel style 2018-05-07 09:34:12 -04:00
README wandboard: README: Include the mx6qp variant in the list 2018-09-14 15:22:52 +02:00
spl.c imx6: wandboard: convert to DM_MMC 2019-04-13 20:30:09 +02:00
wandboard.c imx6: wandboard: convert to DM_MMC 2019-04-13 20:30:09 +02:00

U-Boot for Wandboard
--------------------

This file contains information for the port of U-Boot to the Wandboard.

Wandboard is a development board that has three variants based on the following
SoCs: mx6 quad, mx6 quad plus, mx6 dual lite and mx6 solo.

For more details about Wandboard, please refer to:
http://www.wandboard.org/

Building U-Boot for Wandboard
-----------------------------

To build U-Boot for the Wandboard:

$ make wandboard_config
$ make

Flashing U-Boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'SPL' binary must be
flashed into the SD card;

$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

(Note - the SD card node may vary, so adjust this as needed).

- Flash the u-boot.img image into the SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)

- Connect the serial cable to the host PC

- Power up the board and U-Boot messages will appear in the serial console.