mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-17 18:28:55 +00:00
1d1f3c8099
Make the conversion to driver model as it is mandatory. Successfully tested booting Linux from the SD card. Dropped support for networking and splash screen as these need to be properly converted to DM and tested. Signed-off-by: Fabio Estevam <festevam@gmail.com> |
||
|---|---|---|
| .. | ||
| iomux.c | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| mx28evk.c | ||
| README | ||
FREESCALE MX28EVK ================== Supported hardware: MX28EVK rev C and D are supported in U-Boot. Files of the MX28EVK port -------------------------- arch/arm/cpu/arm926ejs/mxs/ - The CPU support code for the Freescale i.MX28 arch/arm/include/asm/arch-mxs/ - Header files for the Freescale i.MX28 board/freescale/mx28evk/ - MX28EVK board specific files include/configs/mx28evk.h - MX28EVK configuration file Jumper configuration --------------------- To boot MX28EVK from an SD card, set the boot mode DIP switches as: * Boot Mode Select: 1 0 0 1 (Boot from SD card Slot 0 - U42) * JTAG PSWITCH RESET: To the right (reset disabled) * Battery Source: Down * Wall 5V: Up * VDD 5V: To the left (off) * Hold Button: Down (off) To boot MX28EVK from SPI NOR flash, set the boot mode DIP switches as: * Boot Mode Select: 0 0 1 0 (Boot from SSP2) * JTAG PSWITCH RESET: To the right (reset disabled) * Battery Source: Down * Wall 5V: Up * VDD 5V: To the left (off) * Hold Button: Down (off) Environment Storage ------------------- There are three targets for mx28evk: "make mx28evk_config" - store environment variables into MMC or "make mx28evk_nand_config" - store environment variables into NAND flash or "make mx28evk_spi_config" - store environment variables into SPI NOR flash Choose the target accordingly. Note: The mx28evk board does not come with a NAND flash populated from the factory. It comes with an empty slot (U23), which allows the insertion of a 48-pin TSOP flash device. mx28evk does not come with SPI NOR flash populated from the factory either. It is possible to solder a SOIC memory on U49 or use a DIP8 on J89. To get SPI communication to work R320, R321,R322 and C178 need to be populated. Look in the schematics for the proper component values. Follow the instructions from doc/imx/common/mxs.txt to generate a bootable SD card or to generate a binary to be flashed into SPI NOR.