u-boot/include/spi_flash.h
Lukasz Majewski 56c4046038 spi: Convert CONFIG_DM_SPI* to CONFIG_$(SPL_TPL_)DM_SPI*
This change allows more fine tuning of driver model based SPI support in
SPL and TPL. It is now possible to explicitly enable/disable the DM_SPI
support in SPL and TPL via Kconfig option.

Before this change it was necessary to use:
    /* SPI Flash Configs */
    #if defined(CONFIG_SPL_BUILD)
    #undef CONFIG_DM_SPI
    #undef CONFIG_DM_SPI_FLASH
    #undef CONFIG_SPI_FLASH_MTD
    #endif

in the ./include/configs/<board>.h, which is error prone and shall be
avoided when we strive to switch to Kconfig.

The goal of this patch:

Provide distinction for DM_SPI support in both U-Boot proper and SPL (TPL).
Valid use case is when U-Boot proper wants to use DM_SPI, but SPL must
still support non DM driver.

Another use case is the conversion of non DM/DTS SPI driver to support
DM/DTS. When such driver needs to work in both SPL and U-Boot proper, the
distinction is needed in Kconfig (also if SPL version of the driver
supports OF_PLATDATA).

In the end of the day one would have to support following use cases (in
single driver file - e.g. mxs_spi.c):

- U-Boot proper driver supporting DT/DTS
- U-Boot proper driver without DT/DTS support (deprecated)
- SPL driver without DT/DTS support
- SPL (and TPL) driver with DT/DTS (when the SoC has enough resources to
  run full blown DT/DTS)
- SPL driver with DT/DTS and SPL_OF_PLATDATA (when one have constrained
  environment with no fitImage and OF_LIBFDT support).

Some boards do require SPI support (with DM) in SPL (TPL) and some only
have DM_SPI{_FLASH} defined to allow compiling SPL.

This patch converts #ifdef CONFIG_DM_SPI* to #if CONFIG_IS_ENABLED(DM_SPI)
and provides corresponding defines in Kconfig.

Signed-off-by: Lukasz Majewski <lukma@denx.de>
Tested-by: Adam Ford <aford173@gmail.com> #da850-evm
Signed-off-by: Hou Zhiqiang <Zhiqiang.Hou@nxp.com>
[trini: Fixup a few platforms]
Signed-off-by: Tom Rini <trini@konsulko.com>
2020-06-29 13:34:43 -04:00

181 lines
4.9 KiB
C

/* SPDX-License-Identifier: GPL-2.0 */
/*
* Common SPI flash Interface
*
* Copyright (C) 2008 Atmel Corporation
* Copyright (C) 2013 Jagannadha Sutradharudu Teki, Xilinx Inc.
*/
#ifndef _SPI_FLASH_H_
#define _SPI_FLASH_H_
#include <dm.h> /* Because we dereference struct udevice here */
#include <linux/types.h>
#include <linux/mtd/spi-nor.h>
/* by default ENV use the same parameters than SF command */
#ifndef CONFIG_ENV_SPI_BUS
# define CONFIG_ENV_SPI_BUS CONFIG_SF_DEFAULT_BUS
#endif
#ifndef CONFIG_ENV_SPI_CS
# define CONFIG_ENV_SPI_CS CONFIG_SF_DEFAULT_CS
#endif
#ifndef CONFIG_ENV_SPI_MAX_HZ
# define CONFIG_ENV_SPI_MAX_HZ CONFIG_SF_DEFAULT_SPEED
#endif
#ifndef CONFIG_ENV_SPI_MODE
# define CONFIG_ENV_SPI_MODE CONFIG_SF_DEFAULT_MODE
#endif
struct spi_slave;
struct dm_spi_flash_ops {
int (*read)(struct udevice *dev, u32 offset, size_t len, void *buf);
int (*write)(struct udevice *dev, u32 offset, size_t len,
const void *buf);
int (*erase)(struct udevice *dev, u32 offset, size_t len);
};
/* Access the serial operations for a device */
#define sf_get_ops(dev) ((struct dm_spi_flash_ops *)(dev)->driver->ops)
#if CONFIG_IS_ENABLED(DM_SPI_FLASH)
/**
* spi_flash_read_dm() - Read data from SPI flash
*
* @dev: SPI flash device
* @offset: Offset into device in bytes to read from
* @len: Number of bytes to read
* @buf: Buffer to put the data that is read
* @return 0 if OK, -ve on error
*/
int spi_flash_read_dm(struct udevice *dev, u32 offset, size_t len, void *buf);
/**
* spi_flash_write_dm() - Write data to SPI flash
*
* @dev: SPI flash device
* @offset: Offset into device in bytes to write to
* @len: Number of bytes to write
* @buf: Buffer containing bytes to write
* @return 0 if OK, -ve on error
*/
int spi_flash_write_dm(struct udevice *dev, u32 offset, size_t len,
const void *buf);
/**
* spi_flash_erase_dm() - Erase blocks of the SPI flash
*
* Note that @len must be a muiltiple of the flash sector size.
*
* @dev: SPI flash device
* @offset: Offset into device in bytes to start erasing
* @len: Number of bytes to erase
* @return 0 if OK, -ve on error
*/
int spi_flash_erase_dm(struct udevice *dev, u32 offset, size_t len);
/**
* spi_flash_std_probe() - Probe a SPI flash device
*
* This is the standard internal method for probing a SPI flash device to
* determine its type. It can be used in chip-specific drivers which need to
* do this, typically with of-platdata
*
* @dev: SPI-flash device to probe
* @return 0 if OK, -ve on error
*/
int spi_flash_std_probe(struct udevice *dev);
int spi_flash_probe_bus_cs(unsigned int busnum, unsigned int cs,
unsigned int max_hz, unsigned int spi_mode,
struct udevice **devp);
/* Compatibility function - this is the old U-Boot API */
struct spi_flash *spi_flash_probe(unsigned int bus, unsigned int cs,
unsigned int max_hz, unsigned int spi_mode);
/* Compatibility function - this is the old U-Boot API */
void spi_flash_free(struct spi_flash *flash);
static inline int spi_flash_read(struct spi_flash *flash, u32 offset,
size_t len, void *buf)
{
return spi_flash_read_dm(flash->dev, offset, len, buf);
}
static inline int spi_flash_write(struct spi_flash *flash, u32 offset,
size_t len, const void *buf)
{
return spi_flash_write_dm(flash->dev, offset, len, buf);
}
static inline int spi_flash_erase(struct spi_flash *flash, u32 offset,
size_t len)
{
return spi_flash_erase_dm(flash->dev, offset, len);
}
struct sandbox_state;
int sandbox_sf_bind_emul(struct sandbox_state *state, int busnum, int cs,
struct udevice *bus, ofnode node, const char *spec);
void sandbox_sf_unbind_emul(struct sandbox_state *state, int busnum, int cs);
#else
struct spi_flash *spi_flash_probe(unsigned int bus, unsigned int cs,
unsigned int max_hz, unsigned int spi_mode);
void spi_flash_free(struct spi_flash *flash);
static inline int spi_flash_read(struct spi_flash *flash, u32 offset,
size_t len, void *buf)
{
struct mtd_info *mtd = &flash->mtd;
size_t retlen;
return mtd->_read(mtd, offset, len, &retlen, buf);
}
static inline int spi_flash_write(struct spi_flash *flash, u32 offset,
size_t len, const void *buf)
{
struct mtd_info *mtd = &flash->mtd;
size_t retlen;
return mtd->_write(mtd, offset, len, &retlen, buf);
}
static inline int spi_flash_erase(struct spi_flash *flash, u32 offset,
size_t len)
{
struct mtd_info *mtd = &flash->mtd;
struct erase_info instr;
if (offset % mtd->erasesize || len % mtd->erasesize) {
printf("SF: Erase offset/length not multiple of erase size\n");
return -EINVAL;
}
memset(&instr, 0, sizeof(instr));
instr.addr = offset;
instr.len = len;
return mtd->_erase(mtd, &instr);
}
#endif
static inline int spi_flash_protect(struct spi_flash *flash, u32 ofs, u32 len,
bool prot)
{
if (!flash->flash_lock || !flash->flash_unlock)
return -EOPNOTSUPP;
if (prot)
return flash->flash_lock(flash, ofs, len);
else
return flash->flash_unlock(flash, ofs, len);
}
#endif /* _SPI_FLASH_H_ */