mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-27 07:01:24 +00:00
9a8804a85e
There are two revisions of wandboard: version B1 and C1. Add the revision detection support, so that the correct dtb file can be automatically loaded. Based on the patch from Richard Hu <hakahu@gmail.com>. Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com> Reviewed-by: Stefano Babic <sbabic@denx.de> Tested-By: Vagrant Cascadian <vagrant@aikidev.net> |
||
---|---|---|
.. | ||
Kconfig | ||
MAINTAINERS | ||
Makefile | ||
README | ||
spl.c | ||
wandboard.c |
U-Boot for Wandboard -------------------- This file contains information for the port of U-Boot to the Wandboard. Wandboard is a development board that has three variants based on the following SoCs: mx6 quad, mx6 dual lite and mx6 solo. For more details about Wandboard, please refer to: http://www.wandboard.org/ Building U-boot for Wandboard ----------------------------- To build U-Boot for the Wandboard: $ make wandboard_config $ make Flashing U-boot into the SD card -------------------------------- - After the 'make' command completes, the generated 'SPL' binary must be flashed into the SD card; $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync (Note - the SD card node may vary, so adjust this as needed). - Flash the u-boot.img image into the SD card: sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync - Insert the SD card into the slot located in the bottom of the board (same side as the mx6 processor) - Connect the serial cable to the host PC - Power up the board and U-boot messages will appear in the serial console.