u-boot/configs/trimslice_defconfig
Patrick Delaunay abe66b1b5d Convert CONFIG_ENV_SPI_* to Kconfig
This converts the following to Kconfig:
  CONFIG_ENV_SPI_BUS
  CONFIG_ENV_SPI_CS
  CONFIG_ENV_SPI_MAX_HZ
  CONFIG_ENV_SPI_MODE

Most of time these value are not needed, CONFIG_SF_DEFAULT
with same value is used, so I introduced CONFIG_USE_ENV_SPI_*
to force the associated value for the environment.

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
2019-03-25 17:36:59 -04:00

46 lines
1.1 KiB
Text

CONFIG_ARM=y
CONFIG_TEGRA=y
CONFIG_SYS_TEXT_BASE=0x00110000
CONFIG_TEGRA20=y
CONFIG_TARGET_TRIMSLICE=y
CONFIG_NR_DRAM_BANKS=2
CONFIG_OF_SYSTEM_SETUP=y
CONFIG_CONSOLE_MUX=y
CONFIG_SYS_STDIO_DEREGISTER=y
CONFIG_SYS_PROMPT="Tegra20 (TrimSlice) # "
# CONFIG_CMD_IMI is not set
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_PCI=y
CONFIG_CMD_SF=y
CONFIG_CMD_SPI=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SETEXPR is not set
# CONFIG_CMD_NFS is not set
CONFIG_CMD_EXT4_WRITE=y
# CONFIG_SPL_DOS_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_DEFAULT_DEVICE_TREE="tegra20-trimslice"
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_USE_ENV_SPI_MAX_HZ=y
CONFIG_ENV_SPI_MAX_HZ=48000000
CONFIG_SPL_DM=y
CONFIG_SYS_I2C_TEGRA=y
CONFIG_SPI_FLASH=y
CONFIG_SF_DEFAULT_MODE=0
CONFIG_SPI_FLASH_WINBOND=y
CONFIG_RTL8169=y
CONFIG_PCI=y
CONFIG_DM_PCI=y
CONFIG_DM_PCI_COMPAT=y
CONFIG_PCI_TEGRA=y
CONFIG_SYS_NS16550=y
CONFIG_TEGRA20_SFLASH=y
CONFIG_USB=y
CONFIG_DM_USB=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_EHCI_TEGRA=y
CONFIG_USB_HOST_ETHER=y
CONFIG_USB_ETHER_ASIX=y