u-boot/arch/arm/mach-socfpga/spl.c
Marek Vasut 066ad14a22 arm: socfpga: spl: Add support for selecting boot device from BSEL
Rework spl_boot_device() such that it reads the BSEL settings from
system manager and decides from where to load U-Boot based on this
information.

Signed-off-by: Marek Vasut <marex@denx.de>
2015-08-08 14:14:08 +02:00

182 lines
4.6 KiB
C

/*
* Copyright (C) 2012 Altera Corporation <www.altera.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/io.h>
#include <asm/pl310.h>
#include <asm/u-boot.h>
#include <asm/utils.h>
#include <image.h>
#include <asm/arch/reset_manager.h>
#include <spl.h>
#include <asm/arch/system_manager.h>
#include <asm/arch/freeze_controller.h>
#include <asm/arch/clock_manager.h>
#include <asm/arch/scan_manager.h>
#include <asm/arch/sdram.h>
#include <asm/arch/scu.h>
#include <asm/arch/nic301.h>
DECLARE_GLOBAL_DATA_PTR;
static struct pl310_regs *const pl310 =
(struct pl310_regs *)CONFIG_SYS_PL310_BASE;
static struct scu_registers *scu_regs =
(struct scu_registers *)SOCFPGA_MPUSCU_ADDRESS;
static struct nic301_registers *nic301_regs =
(struct nic301_registers *)SOCFPGA_L3REGS_ADDRESS;
static struct socfpga_system_manager *sysmgr_regs =
(struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS;
u32 spl_boot_device(void)
{
const u32 bsel = readl(&sysmgr_regs->bootinfo);
switch (bsel & 0x7) {
case 0x1: /* FPGA (HPS2FPGA Bridge) */
return BOOT_DEVICE_RAM;
case 0x2: /* NAND Flash (1.8V) */
case 0x3: /* NAND Flash (3.0V) */
return BOOT_DEVICE_NAND;
case 0x4: /* SD/MMC External Transceiver (1.8V) */
case 0x5: /* SD/MMC Internal Transceiver (3.0V) */
socfpga_per_reset(SOCFPGA_RESET(SDMMC), 0);
socfpga_per_reset(SOCFPGA_RESET(DMA), 0);
return BOOT_DEVICE_MMC1;
case 0x6: /* QSPI Flash (1.8V) */
case 0x7: /* QSPI Flash (3.0V) */
socfpga_per_reset(SOCFPGA_RESET(QSPI), 0);
return BOOT_DEVICE_SPI;
default:
printf("Invalid boot device (bsel=%08x)!\n", bsel);
hang();
}
}
#ifdef CONFIG_SPL_MMC_SUPPORT
u32 spl_boot_mode(void)
{
#if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT)
return MMCSD_MODE_FS;
#else
return MMCSD_MODE_RAW;
#endif
}
#endif
static void socfpga_nic301_slave_ns(void)
{
writel(0x1, &nic301_regs->lwhps2fpgaregs);
writel(0x1, &nic301_regs->hps2fpgaregs);
writel(0x1, &nic301_regs->acp);
writel(0x1, &nic301_regs->rom);
writel(0x1, &nic301_regs->ocram);
writel(0x1, &nic301_regs->sdrdata);
}
void board_init_f(ulong dummy)
{
#ifndef CONFIG_SOCFPGA_VIRTUAL_TARGET
const struct cm_config *cm_default_cfg = cm_get_default_config();
#endif
unsigned long sdram_size;
unsigned long reg;
/*
* First C code to run. Clear fake OCRAM ECC first as SBE
* and DBE might triggered during power on
*/
reg = readl(&sysmgr_regs->eccgrp_ocram);
if (reg & SYSMGR_ECC_OCRAM_SERR)
writel(SYSMGR_ECC_OCRAM_SERR | SYSMGR_ECC_OCRAM_EN,
&sysmgr_regs->eccgrp_ocram);
if (reg & SYSMGR_ECC_OCRAM_DERR)
writel(SYSMGR_ECC_OCRAM_DERR | SYSMGR_ECC_OCRAM_EN,
&sysmgr_regs->eccgrp_ocram);
memset(__bss_start, 0, __bss_end - __bss_start);
socfpga_nic301_slave_ns();
/* Configure ARM MPU SNSAC register. */
setbits_le32(&scu_regs->sacr, 0xfff);
/* Remap SDRAM to 0x0 */
writel(0x1, &nic301_regs->remap); /* remap.mpuzero */
writel(0x1, &pl310->pl310_addr_filter_start);
#ifndef CONFIG_SOCFPGA_VIRTUAL_TARGET
debug("Freezing all I/O banks\n");
/* freeze all IO banks */
sys_mgr_frzctrl_freeze_req();
/* Put everything into reset but L4WD0. */
socfpga_per_reset_all();
/* Put FPGA bridges into reset too. */
socfpga_bridges_reset(1);
socfpga_per_reset(SOCFPGA_RESET(SDR), 0);
socfpga_per_reset(SOCFPGA_RESET(UART0), 0);
socfpga_per_reset(SOCFPGA_RESET(OSC1TIMER0), 0);
timer_init();
debug("Reconfigure Clock Manager\n");
/* reconfigure the PLLs */
cm_basic_init(cm_default_cfg);
/* Enable bootrom to configure IOs. */
sysmgr_config_warmrstcfgio(1);
/* configure the IOCSR / IO buffer settings */
if (scan_mgr_configure_iocsr())
hang();
sysmgr_config_warmrstcfgio(0);
/* configure the pin muxing through system manager */
sysmgr_config_warmrstcfgio(1);
sysmgr_pinmux_init();
sysmgr_config_warmrstcfgio(0);
#endif /* CONFIG_SOCFPGA_VIRTUAL_TARGET */
/* De-assert reset for peripherals and bridges based on handoff */
reset_deassert_peripherals_handoff();
socfpga_bridges_reset(0);
debug("Unfreezing/Thaw all I/O banks\n");
/* unfreeze / thaw all IO banks */
sys_mgr_frzctrl_thaw_req();
/* enable console uart printing */
preloader_console_init();
if (sdram_mmr_init_full(0xffffffff) != 0) {
puts("SDRAM init failed.\n");
hang();
}
debug("SDRAM: Calibrating PHY\n");
/* SDRAM calibration */
if (sdram_calibration_full() == 0) {
puts("SDRAM calibration failed.\n");
hang();
}
sdram_size = sdram_calculate_size();
debug("SDRAM: %ld MiB\n", sdram_size >> 20);
/* Sanity check ensure correct SDRAM size specified */
if (get_ram_size(0, sdram_size) != sdram_size) {
puts("SDRAM size check failed!\n");
hang();
}
socfpga_bridges_reset(1);
board_init_r(NULL, 0);
}