u-boot/board/freescale/imx8mn_evk
Peng Fan 3c41728d80 imx8m: Refactor the OPTEE memory removal
Current codes assume the OPTEE address is at the end of first DRAM bank.
Adjust the process to allow OPTEE in the middle of first bank.

When OPTEE memory is removed from first bank, it may split the first bank
to two banks, adjust the MMU table for the split case,
Since the default CONFIG_NR_DRAM_BANKS is 4, it is enough, just enlarge
i.MX8MP evk to default to avoid issue.

Signed-off-by: Ye Li <ye.li@nxp.com>
Signed-off-by: Silvano di Ninno <silvano.dininno@nxp.com>
Tested-by: Silvano di Ninno <silvano.dininno@nxp.com>
Signed-off-by: Peng Fan <peng.fan@nxp.com>
2020-07-14 15:23:48 +08:00
..
ddr4_timing.c imx: add i.MX8MN DDR4 board support 2019-11-05 10:27:18 +01:00
imx8mn_evk.c imx8m: Refactor the OPTEE memory removal 2020-07-14 15:23:48 +08:00
Kconfig imx: add i.MX8MN DDR4 board support 2019-11-05 10:27:18 +01:00
MAINTAINERS imx: add i.MX8MN DDR4 board support 2019-11-05 10:27:18 +01:00
Makefile imx: add i.MX8MN DDR4 board support 2019-11-05 10:27:18 +01:00
README imx8mn: evk: add README 2020-01-08 13:20:09 +01:00
spl.c common: Drop log.h from common header 2020-05-18 21:19:18 -04:00

U-Boot for the NXP i.MX8MN EVK board

Quick Start
===========
- Build the ARM Trusted firmware binary
- Get firmware-imx package
- Build U-Boot
- Boot

Get and Build the ARM Trusted firmware
======================================
Note: srctree is U-Boot source directory
Get ATF from: https://source.codeaurora.org/external/imx/imx-atf
branch: imx_4.19.35_1.1.0
$ make PLAT=imx8mn bl31
$ cp build/imx8mn/release/bl31.bin $(srctree)

Get the ddr firmware
=============================
$ wget https://www.nxp.com/lgfiles/NMG/MAD/YOCTO/firmware-imx-8.5.bin
$ chmod +x firmware-imx-8.5.bin
$ ./firmware-imx-8.5
$ cp firmware-imx-8.5/firmware/ddr/synopsys/ddr4*.bin $(srctree)

Build U-Boot
============
$ export CROSS_COMPILE=aarch64-poky-linux-
$ make imx8mn_ddr4_evk_defconfig
$ export ATF_LOAD_ADDR=0x960000
$ make flash.bin

Burn the flash.bin to MicroSD card offset 32KB
$sudo dd if=flash.bin of=/dev/sd[x] bs=1024 seek=32

Boot
====
Set Boot switch to SD boot