u-boot/board/freescale/t104xrdb/eth.c
Shaohui Xie b0615f0bd2 powerpc/t1040rdb: added a break in switch case
There should be a break for case PHY_INTERFACE_MODE_SGMII, otherwise it
will fall into case PHY_INTERFACE_MODE_RGMII.

Signed-off-by: Shaohui Xie <Shaohui.Xie@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
2014-04-22 17:58:52 -07:00

73 lines
1.7 KiB
C

/*
* Copyright 2014 Freescale Semiconductor, Inc.
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <netdev.h>
#include <asm/immap_85xx.h>
#include <fm_eth.h>
#include <fsl_mdio.h>
#include <malloc.h>
#include <asm/fsl_dtsec.h>
#include "../common/fman.h"
int board_eth_init(bd_t *bis)
{
#ifdef CONFIG_FMAN_ENET
struct memac_mdio_info memac_mdio_info;
unsigned int i;
int phy_addr = 0;
printf("Initializing Fman\n");
memac_mdio_info.regs =
(struct memac_mdio_controller *)CONFIG_SYS_FM1_DTSEC_MDIO_ADDR;
memac_mdio_info.name = DEFAULT_FM_MDIO_NAME;
/* Register the real 1G MDIO bus */
fm_memac_mdio_init(bis, &memac_mdio_info);
/*
* Program on board RGMII, SGMII PHY addresses.
*/
for (i = FM1_DTSEC1; i < FM1_DTSEC1 + CONFIG_SYS_NUM_FM1_DTSEC; i++) {
int idx = i - FM1_DTSEC1;
switch (fm_info_get_enet_if(i)) {
#ifdef CONFIG_T1040RDB
case PHY_INTERFACE_MODE_SGMII:
/* T1040RDB only supports SGMII on DTSEC3 */
fm_info_set_phy_address(FM1_DTSEC3,
CONFIG_SYS_SGMII1_PHY_ADDR);
break;
#endif
case PHY_INTERFACE_MODE_RGMII:
if (FM1_DTSEC4 == i)
phy_addr = CONFIG_SYS_RGMII1_PHY_ADDR;
if (FM1_DTSEC5 == i)
phy_addr = CONFIG_SYS_RGMII2_PHY_ADDR;
fm_info_set_phy_address(i, phy_addr);
break;
case PHY_INTERFACE_MODE_QSGMII:
fm_info_set_phy_address(i, 0);
break;
case PHY_INTERFACE_MODE_NONE:
fm_info_set_phy_address(i, 0);
break;
default:
printf("Fman1: DTSEC%u set to unknown interface %i\n",
idx + 1, fm_info_get_enet_if(i));
fm_info_set_phy_address(i, 0);
break;
}
fm_info_set_mdio(i,
miiphy_get_dev_by_name(DEFAULT_FM_MDIO_NAME));
}
cpu_eth_init(bis);
#endif
return pci_eth_init(bis);
}