// SPDX-License-Identifier: GPL-2.0+ #include "rk3399-u-boot.dtsi" #ifdef CONFIG_TARGET_PUMA_RK3399_RAM_DDR3_1333 #include "rk3399-sdram-ddr3-1333.dtsi" #endif #ifdef CONFIG_TARGET_PUMA_RK3399_RAM_DDR3_1600 #include "rk3399-sdram-ddr3-1600.dtsi" #endif #ifdef CONFIG_TARGET_PUMA_RK3399_RAM_DDR3_1866 #include "rk3399-sdram-ddr3-1866.dtsi" #endif / { config { u-boot,spl-payload-offset = <0x80000>; /* @ 512KB */ u-boot,mmc-env-offset = <0x5000>; /* @ 20KB */ u-boot,efi-partition-entries-offset = <0x200000>; /* 2MB */ u-boot,boot-led = "module_led"; sysreset-gpio = <&gpio1 RK_PA6 GPIO_ACTIVE_HIGH>; }; chosen { stdout-path = "serial0:115200n8"; u-boot,spl-boot-order = \ "same-as-spl", &norflash, &sdhci, &sdmmc; }; aliases { spi5 = &spi5; }; vdd_log: vdd-log { compatible = "pwm-regulator"; pwms = <&pwm2 0 25000 1>; regulator-name = "vdd_log"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <800000>; regulator-max-microvolt = <1400000>; regulator-init-microvolt = <950000>; vin-supply = <&vcc5v0_sys>; }; }; &binman { simple-bin { fit { offset = <((CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR - 64) * 512)>; }; }; #ifdef CONFIG_ROCKCHIP_SPI_IMAGE simple-bin-spi { fit { /* same as u-boot,spl-payload-offset */ offset = <0x80000>; }; }; #endif }; &gpio1 { u-boot,dm-pre-reloc; }; &gpio3 { u-boot,dm-pre-reloc; /* * The Qseven BIOS_DISABLE signal on the RK3399-Q7 keeps the on-module * eMMC and SPI flash powered-down initially (in fact it keeps the * reset signal asserted). BIOS_DISABLE_OVERRIDE pin allows to re-enable * eMMC and SPI after the SPL has been booted from SD Card. */ bios_disable_override { u-boot,dm-pre-reloc; gpios = ; output-high; line-name = "bios_disable_override"; gpio-hog; }; }; &gpio4 { u-boot,dm-pre-reloc; }; &norflash { u-boot,dm-pre-reloc; }; &pcfg_pull_none { u-boot,dm-pre-reloc; }; &pcfg_pull_up { u-boot,dm-pre-reloc; }; &sdmmc_bus4 { u-boot,dm-pre-reloc; }; &sdmmc_clk { u-boot,dm-pre-reloc; }; &sdmmc_cmd { u-boot,dm-pre-reloc; };