// SPDX-License-Identifier: GPL-2.0+ /* * Copyright 2016 Freescale Semiconductor, Inc. */ #include <common.h> #include <fsl_ddr_sdram.h> #include <fsl_ddr_dimm_params.h> #include <asm/global_data.h> #include "ddr.h" #ifdef CONFIG_FSL_DEEP_SLEEP #include <fsl_sleep.h> #endif #include <log.h> #include <asm/arch/clock.h> DECLARE_GLOBAL_DATA_PTR; void fsl_ddr_board_options(memctl_options_t *popts, dimm_params_t *pdimm, unsigned int ctrl_num) { const struct board_specific_parameters *pbsp, *pbsp_highest = NULL; ulong ddr_freq; if (ctrl_num > 1) { printf("Not supported controller number %d\n", ctrl_num); return; } if (!pdimm->n_ranks) return; if (popts->registered_dimm_en) pbsp = rdimms[0]; else pbsp = udimms[0]; /* Get clk_adjust, wrlvl_start, wrlvl_ctl, according to the board ddr * freqency and n_banks specified in board_specific_parameters table. */ ddr_freq = get_ddr_freq(0) / 1000000; while (pbsp->datarate_mhz_high) { if (pbsp->n_ranks == pdimm->n_ranks) { if (ddr_freq <= pbsp->datarate_mhz_high) { popts->clk_adjust = pbsp->clk_adjust; popts->wrlvl_start = pbsp->wrlvl_start; popts->wrlvl_ctl_2 = pbsp->wrlvl_ctl_2; popts->wrlvl_ctl_3 = pbsp->wrlvl_ctl_3; goto found; } pbsp_highest = pbsp; } pbsp++; } if (pbsp_highest) { printf("Error: board specific timing not found for %lu MT/s\n", ddr_freq); printf("Trying to use the highest speed (%u) parameters\n", pbsp_highest->datarate_mhz_high); popts->clk_adjust = pbsp_highest->clk_adjust; popts->wrlvl_start = pbsp_highest->wrlvl_start; popts->wrlvl_ctl_2 = pbsp->wrlvl_ctl_2; popts->wrlvl_ctl_3 = pbsp->wrlvl_ctl_3; } else { panic("DIMM is not supported by this board"); } found: debug("Found timing match: n_ranks %d, data rate %d, rank_gb %d\n", pbsp->n_ranks, pbsp->datarate_mhz_high, pbsp->rank_gb); popts->data_bus_width = 0; /* 64-bit data bus */ popts->bstopre = 0; /* enable auto precharge */ /* * Factors to consider for half-strength driver enable: * - number of DIMMs installed */ popts->half_strength_driver_enable = 0; /* * Write leveling override */ popts->wrlvl_override = 1; popts->wrlvl_sample = 0xf; /* * Rtt and Rtt_WR override */ popts->rtt_override = 0; /* Enable ZQ calibration */ popts->zq_en = 1; popts->ddr_cdr1 = DDR_CDR1_DHC_EN | DDR_CDR1_ODT(DDR_CDR_ODT_80ohm); popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_80ohm) | DDR_CDR2_VREF_TRAIN_EN | DDR_CDR2_VREF_RANGE_2; /* optimize cpo for erratum A-009942 */ popts->cpo_sample = 0x61; } #ifdef CONFIG_TFABOOT int fsl_initdram(void) { gd->ram_size = tfa_get_dram_size(); if (!gd->ram_size) gd->ram_size = fsl_ddr_sdram_size(); return 0; } #else int fsl_initdram(void) { phys_size_t dram_size; #if defined(CONFIG_SPL) && !defined(CONFIG_SPL_BUILD) gd->ram_size = fsl_ddr_sdram_size(); return 0; #else puts("Initializing DDR....using SPD\n"); dram_size = fsl_ddr_sdram(); #endif erratum_a008850_post(); gd->ram_size = dram_size; return 0; } #endif