Commit graph

4 commits

Author SHA1 Message Date
Patrick Delaunay
468f0508b5 stm32mp: stm32prog: add serial link support
Add a support of UART, using the same protocol than MCU STM32.

See "AN5275: USB DFU/USART protocols used in STM32MP1 Series
bootloaders" for details.

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@st.com>
2020-05-14 09:02:12 +02:00
Patrick Delaunay
6ce1f4ad8d stm32mp: stm32prog: add pmic NVM update support
Add a virtual partition to update the pmic non volatile memory.
(on ST board, STPMIC1).

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@st.com>
2020-05-14 09:02:12 +02:00
Patrick Delaunay
936f1aea80 stm32mp: stm32prog: add otp update support
Add a virtual partition to update the STM32MP15x OTP based
on SMC service provided by TF-A.

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@st.com>
2020-05-14 09:02:12 +02:00
Patrick Delaunay
954bd1a923 stm32mp: add the command stm32prog
Add a specific command stm32prog for STM32MP soc family
witch allows to program the boot devices with the tool
STM32CubeProgrammer (http://www.st.com/STM32CubeProg).

This command uses the same UART STM32 protocol than MCU
STM32 with or USB with DFU protocol v1.1 (ithe MCU ST
extension are no supported).

The executed actions are based on a tab separated value file
with a stm32 header, the FlashLayout file
(https://wiki.st.com/stm32mpu/wiki/STM32CubeProgrammer_flashlayout).

This file is parsed by the U-Boot command to:
- initialize the devices
- create the partition table on each device
- initialize the DFU backend to access to not volatile memory
  (NOR/NAND/SD/eMMC) or to virtual device (OTP/PMIC)

Up to STM32PROG_MAX_DEV (5) devices can be updated with a FlashLayout.

The communication between U-Boot and STM32CubeProgrammer is done with
the specific alternate configuration (see "AN5275: USB DFU/USART protocols
used in STM32MP1 Series bootloaders" for details).

The command stm32prog is executed when a boot from USB is detected
(selected with bootpins) and we can program the boot devices with
a simple command (on Windows or Linux):

PC $>  STM32_Programmer_CLI -c port=usb1 -w flaslayout.tsv

1/ the ROM code loads TF-A in embedded RAM (DFU or uart)
2/ TF-A loads flashlayout file and U-Boot in DDR (DFU or uart)
3/ U-Boot executes the stm32prog command (DFU or uart)

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@st.com>
2020-05-14 09:02:12 +02:00