Commit graph

6 commits

Author SHA1 Message Date
Faiz Abbas
6b66d2ee47 ARM: dts: am57xx: Disable voltage switching for SD card
If UHS speed modes are enabled, a compatible SD card switches down to 1.8V
during enumeration. If after this a software reboot/crash takes place and
on-chip ROM tries to enumerate the SD card, the difference in
IO voltages (host @ 3.3V and card @ 1.8V) may end up damaging the card.

The fix for this is to have support for power cycling the card in
hardware (with a PORz/soft-reset line causing a power cycle of the card).
Because the beaglebone X15 (rev A,B and C), am57xx-evms and am57xx-idks don't
have this capability, disable voltage switching for these boards.

The major effect of this is that the maximum supported speed mode is now
high speed(50 MHz) down from SDR104(200 MHz).

Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>
2019-07-26 22:24:11 -04:00
Faiz Abbas
461918d7df ARM: dts: dra7-mmc-iodelay: Add a new pinctrl group for clk line without pullup
During a short period when the bus voltage is switched from 3.3v to 1.8v,
(to enumerate UHS mode), the mmc module is disabled and the mmc IO lines
are kept in a state according to the programmed pad mux pull type.

According to 4.2.4.2 Timing to Switch Signal Voltage in "SD Specifications
Part 1 Physical Layer Specification Version 5.00 February 22, 2016", the
host should hold CLK low for at least 5ms.

In order to keep the card line low during voltage switch, the pad mux of
mmc1_clk line should be configured to pull down.

Add a new pinctrl group for clock line without pullup to be used in boards
where mmc1_clk line is not connected to an external pullup.

Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>
2019-07-26 22:24:10 -04:00
Lokesh Vutla
b4185e4fef ARM: dts: am574x-idk: Add initial support
Add initial dts support for am574x-idk

Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
2018-01-19 15:49:27 -05:00
Lokesh Vutla
4ddaa6ce28 arm: dts: dra7: sync DT with latest Linux
Sync all dra7* specific dts files with the upstream
kernel including changes queued for 4.14

https://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap.git/log/?h=omap-for-v4.14/dt-v3

Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
Reviewed-by: Tom Rini <trini@konsulko.com>
2017-09-11 16:19:48 -04:00
Lokesh Vutla
a0c0b97c6b ARM: dts: am57xx: sync DT with latest Linux
Sync all am57xx based dts files with latest Linux

Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
Reviewed-by: Tom Rini <trini@konsulko.com>
2016-12-04 13:54:53 -05:00
Schuyler Patton
332dddc6a1 ARM: dts: AM572x-IDK Initial Support
Add initial DTS support for AM572-IDK evm.

Reviewed-by: Tom Rini <trini@konsulko.com>
Signed-off-by: Schuyler Patton <spatton@ti.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
2016-06-13 08:56:38 -04:00