When we do not execute a test requiring ExitBootServices do not reset the
system after testing.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Print the CRC32 loaded via the EFI_LOAD_FILE2_PROTOCOL as a hexadecimal
number.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Reviewed-by: Ilias Apalodimas <ilias.apalodimas@linaro.org>
On RISC-V check that the /chosen node has a boot-hartid property.
To run the test configure with CONFIG_CMD_BOOTEFI_SELFTEST=y and issue
setenv efi_selftest device tree
setenv serial# myserial
bootefi selftest
If the test succeeds, it reports the boot-hartid, e.g.
boot-hartid: 1
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Allow specifying the node on which a property is searched.
Test the device tree consistency more rigorously.
Some efi_st_printf() calls have been converted to efi_st_error().
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Before calling do_reset() in the EFI selftest we must restore the global
data pointer.
Fixes: fa63753f86 ("efi_selftest: substitute ResetSystem() by do_reset()")
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
The unit test will reset the system by calling the ResetSystem() runtime
service before or after ExitBootServices() according to the users choice
by setting environment variable efi_selftest to:
* 'reset system' or
* 'reset system runtime'.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Do not execute the block device test if CONFIG_DOS_PARTITION=n.
Imply CONFIG_DOS_PARTITION in Kconfig.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
As variable services are available at runtime we have to expect EFI_SUCCESS
when calling the services.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Move this header out of the common header. Network support is used in
quite a few places but it still does not warrant blanket inclusion.
Note that this net.h header itself has quite a lot in it. It could be
split into the driver-mode support, functions, structures, checksumming,
etc.
Signed-off-by: Simon Glass <sjg@chromium.org>
According to the UEFI spec ACPI tables should be placed in
EfiACPIReclaimMemory. Let's do the same with the device tree.
Suggested-by: Ard Biesheuvel <ardb@kernel.org>
Cc: Grant Likely <grant.likely@arm.com>
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
GetNextVariableName should report the length of the variable including the
final 0x0000 in bytes.
Check this in the unit test.
Increase the buffer size for variable names. 40 bytes is too short.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Provide a unit test loading an initial ramdisk using the
EFI_LOAD_FILE2_PROTOCOL. The test is only executed on request.
An example usage - given a file image with a file system in partition 1
holding file initrd - is:
* Configure the sandbox with
CONFIG_EFI_SELFTEST=y
CONFIG_EFI_LOAD_FILE2_INITRD=y
CONFIG_EFI_INITRD_FILESPEC="host 0:1 initrd"
* Run ./u-boot and execute
host bind 0 image
setenv efi_selftest load initrd
bootefi selftest
This would provide a test output like:
Testing EFI API implementation
Selected test: 'load initrd'
Setting up 'load initrd'
Setting up 'load initrd' succeeded
Executing 'load initrd'
Loaded 12378613 bytes
CRC32 2997478465
Executing 'load initrd' succeeded
Now the size and CRC32 can be compared to the provided file.
Signed-off-by: Ilias Apalodimas <ilias.apalodimas@linaro.org>
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Use the correct protocol in efi_uc_stop() when detaching the driver from
the controller.
Change the block IO unit test for the block device driver to throw an error
instead of a todo if teardown fails.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
For automating testing we should be able to power off the test system.
The implementation of EFI_RESET_SHUTDOWN requires the do_poweroff()
function which is only available if CONFIG_CMD_POWEROFF=y.
Enable CONFIG_CMD_POWEROFF if PSCI reset is available.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Provide a unit test for the EFI_RNG_PROTOCOL.
The list of algorithms is read. Two random numbers are generated. The test
checks that the two numbers differ.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Add the following file to .gitignore
efi_miniapp_file_image_exception.h
Signed-off-by: Sughosh Ganu <sughosh.ganu@linaro.org>
Use efi_miniapp_*.h instead of file enumeration.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Drop inclusion of crc.h in common.h and use the correct header directly
instead.
With this we can drop the conflicting definition in fw_env.h and rely on
the crc.h header, which is already included.
Signed-off-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Tom Rini <trini@konsulko.com>
As we can build relocation code for the sandbox now we should enable the
unit tests that had to be disabled up to now.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
The UEFI spec has this sentence:
"Variables that have runtime access but that are not nonvolatile are
read-only data variables once ExitBootServices() is performed."
At least EDK2 therefore treats variable PlatformLangCodes only as read-only
at runtime. Nowhere do we make this variable read-only in U-Boot.
Do not use variable PlatformLangCodes for testing if the read only
attribute of variables is observed before ExitBootServices().
Fixes: 5a24239c95 ("efi_loader: selftest: enable APPEND_WRITE tests")
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Errors should not only be announced as text but should also result in
EFI_ST_FAILURE being returned.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Now that APPEND_WRITE is supported,
the result check for the only existing test case should be changed to
'todo' to 'error', while two more test cases are added.
Signed-off-by: AKASHI Takahiro <takahiro.akashi@linaro.org>
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
The network should start in status EfiSimpleNetworkStopped.
Add and correct status checks in the simple network protocol.
Correct the unit test:
* Shutdown() and Stop() during setup if needed
* invoke Shutdown() before Stop() when tearing down
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Check that when the WaitForPacket event occurs
EFI_SIMPLE_NETWORK_RECEIVE_INTERRUPT is set.
Check the return value of Receive().
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
To fully demonstrate crash outputs for UEFI images provide a standalone
UEFI application that tries to invoke an illegal opcode.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
We read the address map before assigning the memory for the pages that will
be mapped to virtual addresses. So these pages will overlap with the entry
for EFI_CONVENTIONAL_MEMORY. We have to ensure that every page is described
at most once in the map.
Remove EFI_CONVENTIONAL_MEMORY from the map that we pass to
SetVirtualAddressMap().
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Provide a unit test for SetVirtualAddressMap() and ConvertPointer().
As ConvertPointer() is not implemented yet this will spit out some
warnings.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Boot services are not available after calling ExitBootServices(). So we
should not try to close an event here.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Reviewed-by: Oleksandr Suvorov <oleksandr.suvorov@toradex.com>
Provide a unit test for the variable services at runtime.
Currently we expect EFI_UNSUPPORTED to be returned as the runtime
implementation is still missing.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
The current short description has a typo. Let it stand out clear that we
provide unit tests.
Improve the description of the CMD_BOOTEFI_SELFTEST configuration option.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Reviewed-by: Alexander Graf <agraf@csgraf.de>
EFI_GRAPHICS_OUTPUT_PROTOCOL.QueryMode() must allocate a buffer for the
mode information structure.
Adjust the unit test to free the buffer.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
If any member of the event group is signaled, all members must be set to
signaled and their notification functions have to be queued.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Provide a unit test that checks that the open protocol information is
correctly updated when opening and closing protocols.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
The GetTime() and the SetTime() runtime services are not obligatory. So
let's make them customizable.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
When a protocol is installed the handle should be queued for the
registration key of each registered event. LocateHandle() should return the
first handle from the queue for the registration key and delete it from the
queue.
Implement the queueing.
Correct the selftest.
With the patch the UEFI SCT tests for LocateHandle() are passed without
failure.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
The error here should be marked *todo*.
Signed-off-by: AKASHI Takahiro <takahiro.akashi@linaro.org>
Reviewed-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Implement the SetTime() runtime service.
Extend the real time clock selftest to check setting the clock.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Rename variables to make it clear they refer to the Unicode collation
protocol identified by the EFI_UNICODE_PROTOCOL2_GUID.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
The device path to text protocol is not needed for EBBR compliance. So
let's make it a customizable option.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
The Unicode collation protocol is not needed for EBBR compliance. So let's
make it a customizable option.
The Unicode capitalization table is only needed by this protocol. So let it
depend on the Unicode collation protocol.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Function memcmp() is available in efi_freestanding.c. So we do not remove a
further implementation.
Replace all usages of efi_st_memcmp() by memcmp().
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
