Commit graph

617 commits

Author SHA1 Message Date
Scott Wood
41ef8c716e Don't panic if a controller driver does ecc its own way.
Some hardware, such as the enhanced local bus controller used on some
mpc83xx chips, does ecc transparently when reading and writing data, rather
than providing a generic calculate/correct mechanism that can be exported to
the nand subsystem.

The subsystem should not BUG() when calculate, correct, or hwctl are
missing, if the methods that call them have been overridden.

Signed-off-by: Scott Wood <scottwood@freescale.com>
2008-08-12 11:31:25 -05:00
Stefan Roese
e52b34d40a NAND: Make NAND driver less verbose per default
This patch turns off printing of bad blocks per default upon bootup.
This can always be shown via the "nand bad" command later.

Signed-off-by: Stefan Roese <sr@denx.de>
2008-08-12 11:31:24 -05:00
Stefan Roese
1207226452 NAND: Change nand_wait_ready() to not call nand_wait()
This patch changes nand_wait_ready() to not just call nand_wait(),
since this will send a new command to the NAND chip. We just want to
wait for the chip to become ready here.

Signed-off-by: Stefan Roese <sr@denx.de>
2008-08-12 11:31:22 -05:00
William Juul
5e1dae5c3d Fixing coding style issues
- Fixing leading white spaces
 - Fixing indentation where 4 spaces are used instead of tab
 - Removing C++ comments (//), wherever I introduced them

Signed-off-by: William Juul <william.juul@tandberg.com>
Signed-off-by: Scott Wood <scottwood@freescale.com>
2008-08-12 11:31:17 -05:00
William Juul
4cbb651b29 Remove white space at end.
Signed-off-by: William Juul <william.juul@tandberg.com>
Signed-off-by: Scott Wood <scottwood@freescale.com>
2008-08-12 11:31:16 -05:00
William Juul
cfa460adfd Update MTD to that of Linux 2.6.22.1
A lot changed in the Linux MTD code, since it was last ported from
Linux to U-Boot. This patch takes U-Boot NAND support to the level
of Linux 2.6.22.1 and will enable support for very large NAND devices
(4KB pages) and ease the compatibility between U-Boot and Linux
filesystems.

This patch is tested on two custom boards with PPC and ARM
processors running YAFFS in U-Boot and Linux using gcc-4.1.2
cross compilers.

MAKEALL ppc/arm has some issues:
 * DOC/OneNand/nand_spl is not building (I have not tried porting
   these parts, and since I do not have any HW and I am not familiar
   with this code/HW I think its best left to someone else.)

Except for the issues mentioned above, I have ported all drivers
necessary to run MAKEALL ppc/arm without errors and warnings. Many
drivers were trivial to port, but some were not so trivial. The
following drivers must be examined carefully and maybe rewritten to
some degree:
 cpu/ppc4xx/ndfc.c
 cpu/arm926ejs/davinci/nand.c
 board/delta/nand.c
 board/zylonite/nand.c

Signed-off-by: William Juul <william.juul@tandberg.com>
Signed-off-by: Stig Olsen <stig.olsen@tandberg.com>
Signed-off-by: Scott Wood <scottwood@freescale.com>
2008-08-12 11:31:15 -05:00
Stefan Roese
e870690bdc MTD/NAND: Fix printf format warning in nand code
This patch fixes NAND related printf format warning. Those warnings are
now visible since patch dc4b0b38d4
[Fix printf errors.] by Andrew Klossner has been applied. Thanks, this is
really helpful.

Signed-off-by: Stefan Roese <sr@denx.de>
2008-07-10 10:46:13 +02:00
Scott Wood
3167c5386e NAND: Rename DEBUG to MTDDEBUG to avoid namespace pollution.
This is particularly problematic now that non-NAND-specific code is
including <nand.h>, and thus all debugging code is being compiled
regardless of whether it was requested, as reported by Scott McNutt
<smcnutt@psyent.com>.

Signed-off-by: Scott Wood <scottwood@freescale.com>
2008-07-09 17:24:47 -05:00
Sergei Poselenov
248ae5cfc8 NAND: Added support for 128-bit OOB, adapted
Signed-off-by: Sergei Poselenov <sposelenov@emcraft.com>
2008-06-11 00:30:22 -05:00
Wolfgang Grandegger
a75a57ef6e NAND FSL UPM: driver re-write using the hwcontrol callback
This is a re-write of the NAND FSL UPM driver using the more universal
hwcontrol callback (instead of the cmdfunc callback). Here is a brief
list of furher modifications:

- For the time being, the UPM setup writing the UPM array has been
  removed from the driver and must now be done by the board specific
  code.

- The bus width definition in "struct fsl_upm_nand" is now in bits to
  comply with the corresponding Linux driver and 8, 16 and 32 bit
  accesses are supported.

- chip->dev_read is only set if fun->dev_ready != NULL, which is
  required for boards not connecting the R/B pin.

- A few issue have been fixed with MxMR bit manipulation like in the
  corresponding Linux driver.

Note: I think the "io_addr" field of "struct fsl_upm" could be removed
      as well, because the address is already determined by
      "nand->IO_ADDR_[RW]", but I'm not 100% sure.

This patch has been tested on a TQM8548 modules with the NAND chip
Micron MT29F8G08FABWP.

This patch is based on the following patches posted to this list a few
minutes ago:

  PPC: add accessor macros to clear and set bits in one shot
  83xx/85xx/86xx: add more MxMR local bus definitions

Signed-off-by: Wolfgang Grandegger <wg@grandegger.com>
Acked-by: Anton Vorontsov <avorontsov@ru.mvista.com>
2008-06-10 18:22:26 -05:00
Dirk Behme
9723bbb46a nand: Correct NAND erase percentage output
For NAND erase sizes smaller than one NAND erase block, erase
percentage output becomes grater than 100% e.g.

-- cut --
  > nand info
Device 0: NAND 64MiB 1,8V 8-bit, sector size 16 KiB
  > nand erase 0x100000 0x2000
NAND erase: device 0 offset 0x100000, size 0x2000
Erasing at 0x100000 -- 200% complete.
OK
  >
-- cut --

Correct this and give user a warning that more is erased than specified:

-- cut --
  > nand erase 0x100000 0x2000
NAND erase: device 0 offset 0x100000, size 0x2000
Warning: Erase size 0x00002000 smaller than one erase block 0x00004000
           Erasing 0x00004000 instead
Erasing at 0x100000 -- 100% complete.
OK
  >
-- cut --

Signed-off-by: Dirk Behme <dirk.behme@gmail.com>
2008-05-28 11:06:27 -05:00
Wolfgang Denk
53677ef18e Big white-space cleanup.
This commit gets rid of a huge amount of silly white-space issues.
Especially, all sequences of SPACEs followed by TAB characters get
removed (unless they appear in print statements).

Also remove all embedded "vim:" and "vi:" statements which hide
indentation problems.

Signed-off-by: Wolfgang Denk <wd@denx.de>
2008-05-21 00:14:08 +02:00
Troy Kisky
84c01d3a05 PATCH - Fix oob data copied into supplied buffer
This patch correctly sets the oobavail variable
and fixes a bug where the oob data was not valid when
there where multiple groups in oobfree.

First segment fixes a typo
Second segment fixes a bug where oob data may be copied incorrectly.
Third segment adds an error message when exiting due to write protect.
Forth segment fixes a bug where oobavail may be set incorrectly.

Signed-off-by: Troy Kisky <troy.kisky@boundarydevices.com>
2008-04-21 08:43:46 +02:00
Mike Frysinger
e25cb8d3f4 Remove conflicting NAND ID
There are two NAND entries with ID 0xDC and this obviously causes problems.
In the kernel, they punted the first entry, so we should do the same.

See this upstream e-mail for more info:
http://lists.infradead.org/pipermail/linux-mtd/2007-July/018795.html

Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2008-04-17 14:56:56 -07:00
Anton Vorontsov
cd9d23053d nand: FSL UPM NAND driver
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
2008-01-16 14:14:40 +01:00
Marcel Ziswiler
7817cb2083 fix comments with new drivers organization
Signed-off-by: Marcel Ziswiler <marcel@ziswiler.com>
2008-01-09 21:48:49 +01:00
Jean-Christophe PLAGNIOL-VILLARD
59829cc189 drivers/mtd : move mtd drivers to drivers/mtd
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-25 23:28:52 +01:00