mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-24 21:54:01 +00:00
board: am335x/mux: Do not hang when encountering a bad EEPROM
In most cases, the SPL and u-boot.img will be on the same boot media. Since the SPL was loaded by the boot rom, the pinmux will already have been configured for this media. This, the board will still be able to boot successfully, or at least reach the u-boot console, where more recovery options are available. I've encountered this on a beaglebone black with a corrupted EEPROM. Removing this check allowed the board to boot successfully. I've also seen this on EVM-based boards with an unprogrammed EEPROM. On those boards, for some reason there were no UART messages. This made it look as if the SOC was dead. Remove the hang(), as it is not a fatal error. Also reformat the error message to be clearer as to the cause. The original message made it appear as if the wrong binary was being loaded. Signed-off-by: Alexandru Gagniuc <mr.nuke.me@gmail.com> Reviewed-by: Tom Rini <trini@konsulko.com>
This commit is contained in:
parent
4fa72bd3fc
commit
c19a28bc65
1 changed files with 2 additions and 2 deletions
|
@ -397,7 +397,7 @@ void enable_board_pin_mux(void)
|
|||
configure_module_pin_mux(rmii1_pin_mux);
|
||||
configure_module_pin_mux(spi0_pin_mux);
|
||||
} else {
|
||||
puts("Unknown board, cannot configure pinmux.");
|
||||
hang();
|
||||
/* Unknown board. We might still be able to boot. */
|
||||
puts("Bad EEPROM or unknown board, cannot configure pinmux.");
|
||||
}
|
||||
}
|
||||
|
|
Loading…
Reference in a new issue