u-boot/drivers/ddr/marvell/a38x/ddr_topology_def.h

121 lines
2.1 KiB
C
Raw Normal View History

/* SPDX-License-Identifier: GPL-2.0 */
/*
* Copyright (C) Marvell International Ltd. and its affiliates
*/
#ifndef _DDR_TOPOLOGY_DEF_H
#define _DDR_TOPOLOGY_DEF_H
#include "ddr3_training_ip_def.h"
#include "ddr3_topology_def.h"
#if defined(CONFIG_ARMADA_38X)
#include "ddr3_a38x.h"
#endif
/* bus width in bits */
enum hws_bus_width {
BUS_WIDTH_4,
BUS_WIDTH_8,
BUS_WIDTH_16,
BUS_WIDTH_32
};
enum hws_temperature {
HWS_TEMP_LOW,
HWS_TEMP_NORMAL,
HWS_TEMP_HIGH
};
enum hws_mem_size {
MEM_512M,
MEM_1G,
MEM_2G,
MEM_4G,
MEM_8G,
MEM_SIZE_LAST
};
enum hws_timing {
HWS_TIM_DEFAULT,
HWS_TIM_1T,
HWS_TIM_2T
};
struct bus_params {
/* Chip Select (CS) bitmask (bits 0-CS0, bit 1- CS1 ...) */
u8 cs_bitmask;
/*
* mirror enable/disable
* (bits 0-CS0 mirroring, bit 1- CS1 mirroring ...)
*/
int mirror_enable_bitmask;
/* DQS Swap (polarity) - true if enable */
int is_dqs_swap;
/* CK swap (polarity) - true if enable */
int is_ck_swap;
};
struct if_params {
/* bus configuration */
struct bus_params as_bus_params[MAX_BUS_NUM];
/* Speed Bin Table */
enum hws_speed_bin speed_bin_index;
/* bus width of memory */
enum hws_bus_width bus_width;
/* Bus memory size (MBit) */
enum hws_mem_size memory_size;
/* The DDR frequency for each interfaces */
enum hws_ddr_freq memory_freq;
/*
* delay CAS Write Latency
* - 0 for using default value (jedec suggested)
*/
u8 cas_wl;
/*
* delay CAS Latency
* - 0 for using default value (jedec suggested)
*/
u8 cas_l;
/* operation temperature */
enum hws_temperature interface_temp;
/* 2T vs 1T mode (by default computed from number of CSs) */
enum hws_timing timing;
};
struct hws_topology_map {
/* Number of interfaces (default is 12) */
u8 if_act_mask;
/* Controller configuration per interface */
struct if_params interface_params[MAX_INTERFACE_NUM];
/* BUS per interface (default is 4) */
u8 num_of_bus_per_interface;
/* Bit mask for active buses */
u8 bus_act_mask;
};
/* DDR3 training global configuration parameters */
struct tune_train_params {
u32 ck_delay;
u32 ck_delay_16;
u32 p_finger;
u32 n_finger;
u32 phy_reg3_val;
};
#endif /* _DDR_TOPOLOGY_DEF_H */