u-boot/board/kontron/sl28/Makefile

# SPDX-License-Identifier:	GPL-2.0+

ifndef CONFIG_SPL_BUILD
obj-y += sl28.o cmds.o
endif

obj-y += common.o ddr.o

ifdef CONFIG_SPL_BUILD
obj-y += spl.o
obj-$(CONFIG_SPL_ATF) += spl_atf.o
endif
board: kontron: add sl28 support Add basic support for the Kontron SMARC-sAL28 board. This includes just the bare minimum to be able to bring up the board and boot linux. For now, the Single and Dual PHY variant is supported. Other variants will fall back to the basic variant. In particular, there is no watchdog support for now. This means that you have to disable the default watchdog, otherwise you'll end up in the recovery bootloader. See the board README for details. Signed-off-by: Michael Walle <michael@walle.cc> Reviewed-by: Tom Rini <trini@konsulko.com> Tested-by: Heiko Thiery <heiko.thiery@gmail.com> Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com> 2020-10-15 21:08:57 +00:00			`# SPDX-License-Identifier: GPL-2.0+`

			`ifndef CONFIG_SPL_BUILD`
board: sl28: add board specific nvm command The board supports 16 configuration bits which can be manipulated with this command. See the board's README for a detailed explanation on each bit. Signed-off-by: Michael Walle <michael@walle.cc> Tested-by: Heiko Thiery <heiko.thiery@gmail.com> Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com> 2020-10-15 21:08:58 +00:00			`obj-y += sl28.o cmds.o`
board: kontron: add sl28 support Add basic support for the Kontron SMARC-sAL28 board. This includes just the bare minimum to be able to bring up the board and boot linux. For now, the Single and Dual PHY variant is supported. Other variants will fall back to the basic variant. In particular, there is no watchdog support for now. This means that you have to disable the default watchdog, otherwise you'll end up in the recovery bootloader. See the board README for details. Signed-off-by: Michael Walle <michael@walle.cc> Reviewed-by: Tom Rini <trini@konsulko.com> Tested-by: Heiko Thiery <heiko.thiery@gmail.com> Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com> 2020-10-15 21:08:57 +00:00			`endif`

board: sl28: add config to enable console output on SER0 Sometimes it is desireable to have the console output on the first serial line. Introduce a configuration option for it (in the board scope). Signed-off-by: Michael Walle <michael@walle.cc> Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com> 2021-03-26 18:40:59 +00:00			`obj-y += common.o ddr.o`
board: sl28: add ATF support (bl31) Add support to load the bl31 part of the ARM Trusted Firmware by the SPL. Signed-off-by: Michael Walle <michael@walle.cc> 2020-11-18 16:46:01 +00:00
			`ifdef CONFIG_SPL_BUILD`
			`obj-y += spl.o`
			`obj-$(CONFIG_SPL_ATF) += spl_atf.o`
			`endif`