u-boot/configs/qemu-riscv32_spl_defconfig

CONFIG_RISCV=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_SPL=y
CONFIG_TARGET_QEMU_VIRT=y
CONFIG_RISCV_SMODE=y
CONFIG_DISTRO_DEFAULTS=y
CONFIG_FIT=y
CONFIG_DISPLAY_CPUINFO=y
CONFIG_DISPLAY_BOARDINFO=y
# CONFIG_CMD_MII is not set
CONFIG_OF_PRIOR_STAGE=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
riscv: qemu: add SPL configuration Add two new configurations (qemu-riscv{32,64}_spl_defconfig) with SPL enabled for RISC-V QEMU. QEMU does not require SPL to run U-Boot. The configurations are meant to help the development of SPL on RISC-V. The configurations enable RAM as the only SPL boot device. Images must be loaded at address 0x80200000. In the default boot flow, U-Boot SPL starts in machine mode, loads the OpenSBI FW_DYNAMIC firmware and U-Boot proper from the supplied FIT image, and starts OpenSBI. U-Boot proper is then started in supervisor mode by OpenSBI. Signed-off-by: Lukas Auer <lukas.auer@aisec.fraunhofer.de> Reviewed-by: Bin Meng <bmeng.cn@gmail.com> Tested-by: Bin Meng <bmeng.cn@gmail.com> Reviewed-by: Anup Patel <anup.patel@wdc.com> 2019-08-21 21:14:49 +02:00			`CONFIG_RISCV=y`
			`CONFIG_NR_DRAM_BANKS=1`
			`CONFIG_SPL=y`
			`CONFIG_TARGET_QEMU_VIRT=y`
			`CONFIG_RISCV_SMODE=y`
			`CONFIG_DISTRO_DEFAULTS=y`
			`CONFIG_FIT=y`
			`CONFIG_DISPLAY_CPUINFO=y`
			`CONFIG_DISPLAY_BOARDINFO=y`
			`# CONFIG_CMD_MII is not set`
			`CONFIG_OF_PRIOR_STAGE=y`
env: Add CONFIG_SYS_RELOC_GD_ENV_ADDR symbol Today in initr_reloc_global_data() we use some non-obvious tests to determine if we need to relocate the env_addr within gd or not. In order to facilitate migration of other symbols to Kconfig we need to introduce a new symbol for this particular use case. Cc: Wolfgang Denk <wd@denx.de> Cc: Joe Hershberger <joe.hershberger@ni.com> Signed-off-by: Tom Rini <trini@konsulko.com> 2019-11-12 22:46:36 -05:00			`CONFIG_SYS_RELOC_GD_ENV_ADDR=y`