u-boot/doc/device-tree-bindings/pci/armada8k-pcie.txt

50 lines
1.8 KiB
Text
Raw Normal View History

Armada-8K PCIe DT details:
==========================
Armada-8k uses synopsis designware PCIe controller.
Required properties:
- compatible : should be "marvell,armada8k-pcie", "snps,dw-pcie".
- reg: base addresses and lengths of the pcie control and global control registers.
"ctrl" registers points to the global control registers, while the "config" space
points to the pcie configuration registers as mentioned in dw-pcie dt bindings in the link below.
- interrupt-map-mask and interrupt-map, standard PCI properties to
define the mapping of the PCIe interface to interrupt numbers.
- All other definitions as per generic PCI bindings
See Linux kernel documentation:
"Documentation/devicetree/bindings/pci/designware-pcie.txt"
Optional properties:
PHY support is still not supported for armada-8k, once it will, the following parameters can be used:
- phys : phandle to phy node associated with pcie controller.
- phy-names : must be "pcie-phy"
- marvell,reset-gpio : specifies a gpio that needs to be activated for plug-in
card reset signal release.
Example:
cpm_pcie0: pcie@f2600000 {
compatible = "marvell,armada8k-pcie", "snps,dw-pcie";
reg = <0 0xf2600000 0 0x10000>,
<0 0xf6f00000 0 0x80000>;
reg-names = "ctrl", "config";
#address-cells = <3>;
#size-cells = <2>;
#interrupt-cells = <1>;
device_type = "pci";
dma-coherent;
bus-range = <0 0xff>;
ranges =
/* downstream I/O */
<0x81000000 0 0xf9000000 0 0xf9000000 0 0x10000
/* non-prefetchable memory */
0x82000000 0 0xf6000000 0 0xf6000000 0 0xf00000>;
interrupt-map-mask = <0 0 0 0>;
interrupt-map = <0 0 0 0 &gic 0 GIC_SPI 32 IRQ_TYPE_LEVEL_HIGH>;
interrupts = <GIC_SPI 32 IRQ_TYPE_LEVEL_HIGH>;
num-lanes = <1>;
clocks = <&cpm_syscon0 1 13>;
marvell,reset-gpio = <&cpm_gpio1 20 GPIO_ACTIVE_HIGH>;
status = "disabled";
};