u-boot/board/ipek01/ipek01.c

271 lines
6.3 KiB
C
Raw Normal View History

/*
* (C) Copyright 2003-2004
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
*
* (C) Copyright 2004
* Mark Jonas, Freescale Semiconductor, mark.jonas@motorola.com.
*
* (C) Copyright 2006
* MicroSys GmbH
*
* (C) Copyright 2009
* Wolfgang Grandegger, DENX Software Engineering, wg@denx.de.
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <mpc5xxx.h>
#include <pci.h>
#include <netdev.h>
#include <miiphy.h>
#include <libfdt.h>
#include <mb862xx.h>
#include <video_fb.h>
#include <asm/processor.h>
#include <asm/io.h>
#ifdef CONFIG_OF_LIBFDT
#include <fdt_support.h>
#endif /* CONFIG_OF_LIBFDT */
/* mt46v16m16-75 */
#ifdef CONFIG_MPC5200_DDR
/* Settings for XLB = 132 MHz */
#define SDRAM_MODE 0x018D0000
#define SDRAM_EMODE 0x40090000
#define SDRAM_CONTROL 0x714f0f00
#define SDRAM_CONFIG1 0x73722930
#define SDRAM_CONFIG2 0x47770000
#define SDRAM_TAPDELAY 0x10000000
#else
#error SDRAM is not supported on this board
#endif
DECLARE_GLOBAL_DATA_PTR;
static void sdram_start (int hi_addr)
{
struct mpc5xxx_sdram *sdram = (struct mpc5xxx_sdram *)MPC5XXX_SDRAM;
long hi_addr_bit = hi_addr ? 0x01000000 : 0;
/* unlock mode register */
out_be32 (&sdram->ctrl, SDRAM_CONTROL | 0x80000000 | hi_addr_bit);
/* precharge all banks */
out_be32 (&sdram->ctrl, SDRAM_CONTROL | 0x80000002 | hi_addr_bit);
/* set mode register: extended mode */
out_be32 (&sdram->mode, SDRAM_EMODE);
/* set mode register: reset DLL */
out_be32 (&sdram->mode, SDRAM_MODE | 0x04000000);
/* precharge all banks */
out_be32 (&sdram->ctrl, SDRAM_CONTROL | 0x80000002 | hi_addr_bit);
/* auto refresh */
out_be32 (&sdram->ctrl, SDRAM_CONTROL | 0x80000004 | hi_addr_bit);
/* set mode register */
out_be32 (&sdram->mode, SDRAM_MODE);
/* normal operation */
out_be32 (&sdram->ctrl, SDRAM_CONTROL | hi_addr_bit);
}
/*
* ATTENTION: Although partially referenced dram_init does NOT make real
* use of CONFIG_SYS_SDRAM_BASE. The code does not work if
* CONFIG_SYS_SDRAM_BASE is something else than 0x00000000.
*/
int dram_init(void)
{
struct mpc5xxx_mmap_ctl *mmap_ctl =
(struct mpc5xxx_mmap_ctl *)CONFIG_SYS_MBAR;
struct mpc5xxx_sdram *sdram = (struct mpc5xxx_sdram *)MPC5XXX_SDRAM;
struct mpc5xxx_cdm *cdm = (struct mpc5xxx_cdm *)MPC5XXX_CDM;
ulong dramsize = 0;
ulong dramsize2 = 0;
ulong test1, test2;
/* setup SDRAM chip selects */
out_be32 (&mmap_ctl->sdram0, 0x0000001e); /* 2G at 0x0 */
out_be32 (&mmap_ctl->sdram1, 0x00000000); /* disabled */
/* setup config registers */
out_be32 (&sdram->config1, SDRAM_CONFIG1);
out_be32 (&sdram->config2, SDRAM_CONFIG2);
/* set tap delay */
out_be32 (&cdm->porcfg, SDRAM_TAPDELAY);
/* find RAM size using SDRAM CS0 only */
sdram_start (0);
test1 = get_ram_size ((long *)CONFIG_SYS_SDRAM_BASE, 0x80000000);
sdram_start (1);
test2 = get_ram_size ((long *)CONFIG_SYS_SDRAM_BASE, 0x80000000);
if (test1 > test2) {
sdram_start (0);
dramsize = test1;
} else {
dramsize = test2;
}
/* memory smaller than 1MB is impossible */
if (dramsize < (1 << 20))
dramsize = 0;
/* set SDRAM CS0 size according to the amount of RAM found */
if (dramsize > 0)
out_be32 (&mmap_ctl->sdram0,
0x13 + __builtin_ffs (dramsize >> 20) - 1);
else
out_be32 (&mmap_ctl->sdram1, 0); /* disabled */
/*
* On MPC5200B we need to set the special configuration delay in the
* DDR controller. Please refer to Freescale's AN3221 "MPC5200B SDRAM
* Initialization and Configuration", 3.3.1 SDelay--MBAR + 0x0190:
*
* "The SDelay should be written to a value of 0x00000004. It is
* required to account for changes caused by normal wafer processing
* parameters."
*/
out_be32 (&sdram->sdelay, 0x04);
gd->ram_size = dramsize + dramsize2;
return 0;
}
int checkboard (void)
{
puts ("Board: IPEK01 \n");
return 0;
}
void flash_preinit (void)
{
struct mpc5xxx_lpb *lpb = (struct mpc5xxx_lpb *)MPC5XXX_LPB;
/*
* Now, when we are in RAM, enable flash write
* access for detection process.
* Note that CS_BOOT cannot be cleared when
* executing in flash.
*/
clrbits_be32 (&lpb->cs0_cfg, 0x1); /* clear RO */
}
void flash_afterinit (ulong start, ulong size)
{
struct mpc5xxx_mmap_ctl *mmap_ctl =
(struct mpc5xxx_mmap_ctl *)CONFIG_SYS_MBAR;
#if defined(CONFIG_BOOT_ROM)
/* adjust mapping */
out_be32 (&mmap_ctl->cs1_start, START_REG (start));
out_be32 (&mmap_ctl->cs1_stop, STOP_REG (start, size));
#else
/* adjust mapping */
out_be32 (&mmap_ctl->boot_start, START_REG (start));
out_be32 (&mmap_ctl->cs0_start, START_REG (start));
out_be32 (&mmap_ctl->boot_stop, STOP_REG (start, size));
out_be32 (&mmap_ctl->cs0_stop, STOP_REG (start, size));
#endif
}
extern flash_info_t flash_info[]; /* info for FLASH chips */
int misc_init_r (void)
{
/* adjust flash start */
gd->bd->bi_flashstart = flash_info[0].start[0];
return (0);
}
#ifdef CONFIG_PCI
static struct pci_controller hose;
extern void pci_mpc5xxx_init (struct pci_controller *);
void pci_init_board (void)
{
pci_mpc5xxx_init (&hose);
}
#endif
#ifdef CONFIG_OF_BOARD_SETUP
int ft_board_setup(void *blob, bd_t *bd)
{
ft_cpu_setup (blob, bd);
fdt_fixup_memory (blob, (u64) bd->bi_memstart, (u64) bd->bi_memsize);
return 0;
}
#endif /* CONFIG_OF_BOARD_SETUP */
int board_eth_init(bd_t *bis)
{
cpu_eth_init(bis); /* Built in FEC comes first */
return pci_eth_init(bis);
}
#ifdef CONFIG_VIDEO
extern GraphicDevice mb862xx;
static const gdc_regs init_regs[] = {
{0x0100, 0x00000900},
{0x0020, 0x80190257},
{0x0024, 0x00000000},
{0x0028, 0x00000000},
{0x002c, 0x00000000},
{0x0110, 0x00000000},
{0x0114, 0x00000000},
{0x0118, 0x02570320},
{0x0004, 0x041f0000},
{0x0008, 0x031f031f},
{0x000c, 0x067f0347},
{0x0010, 0x02780000},
{0x0014, 0x0257025c},
{0x0018, 0x00000000},
{0x001c, 0x02570320},
{0x0100, 0x80010900},
{0x0, 0x0}
};
const gdc_regs *board_get_regs (void)
{
return init_regs;
}
/* Returns Lime base address */
unsigned int board_video_init (void)
{
if (mb862xx_probe (CONFIG_SYS_LIME_BASE) != MB862XX_TYPE_LIME)
return 0;
mb862xx.winSizeX = 800;
mb862xx.winSizeY = 600;
mb862xx.gdfIndex = GDF_15BIT_555RGB;
mb862xx.gdfBytesPP = 2;
return CONFIG_SYS_LIME_BASE;
}
#if defined(CONFIG_CONSOLE_EXTRA_INFO)
/*
* Return text to be printed besides the logo.
*/
void video_get_info_str (int line_number, char *info)
{
if (line_number == 1)
strcpy (info, " Board: IPEK01");
else
info[0] = '\0';
}
#endif
#endif /* CONFIG_VIDEO */