u-boot/arch/arm/cpu/armv7/bcm281xx/Makefile

# SPDX-License-Identifier: GPL-2.0+
#
# Copyright 2013 Broadcom Corporation.

obj-y	+= reset.o
obj-y	+= clk-core.o
obj-y	+= clk-bcm281xx.o
obj-y	+= clk-sdio.o
obj-y	+= clk-bsc.o
obj-$(CONFIG_BCM_SF2_ETH) += clk-eth.o
obj-y	+= clk-usb-otg.o
SPDX: Convert all of our single license tags to Linux Kernel style When U-Boot started using SPDX tags we were among the early adopters and there weren't a lot of other examples to borrow from. So we picked the area of the file that usually had a full license text and replaced it with an appropriate SPDX-License-Identifier: entry. Since then, the Linux Kernel has adopted SPDX tags and they place it as the very first line in a file (except where shebangs are used, then it's second line) and with slightly different comment styles than us. In part due to community overlap, in part due to better tag visibility and in part for other minor reasons, switch over to that style. This commit changes all instances where we have a single declared license in the tag as both the before and after are identical in tag contents. There's also a few places where I found we did not have a tag and have introduced one. Signed-off-by: Tom Rini <trini@konsulko.com> 2018-05-06 21:58:06 +00:00			`# SPDX-License-Identifier: GPL-2.0+`
arch: bcm281xx: Initial commit of bcm281xx architecture code Add bcm281xx architecture support code including a clock framework and chip reset. Define register block base addresses for the bcm281xx architecture and create an empty gpio header file required when CONFIG_CMD_GPIO is set. Signed-off-by: Darwin Rambo <drambo@broadcom.com> Reviewed-by: Steve Rae <srae@broadcom.com> Reviewed-by: Tim Kryger <tkryger@linaro.org> 2014-02-11 19:06:34 +00:00			`#`
			`# Copyright 2013 Broadcom Corporation.`

			`obj-y += reset.o`
			`obj-y += clk-core.o`
			`obj-y += clk-bcm281xx.o`
			`obj-y += clk-sdio.o`
			`obj-y += clk-bsc.o`
arm: bcm281xx: Add Ethernet Clock support Enable Ethernet clock when Broadcom StarFighter2 Ethernet block (CONFIG_BCM_SF2_ETH) is enabled. Signed-off-by: Jiandong Zheng <jdzheng@broadcom.com> Signed-off-by: Steve Rae <srae@broadcom.com> 2014-08-02 03:37:15 +00:00			`obj-$(CONFIG_BCM_SF2_ETH) += clk-eth.o`
bcm281xx: add support for "USB OTG clock" enable this clock with the following: clk_usb_otg_enable((void *)HSOTG_BASE_ADDR) Signed-off-by: Steve Rae <srae@broadcom.com> Reviewed-by: Felipe Balbi <balbi@ti.com> 2014-12-09 19:40:11 +00:00			`obj-y += clk-usb-otg.o`