mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-18 10:48:51 +00:00
52 lines
1.5 KiB
Text
52 lines
1.5 KiB
Text
|
LEDs connected to Broadcom BCM6858 controller
|
||
|
|
|
||
|
|
This controller is present on BCM6858, BCM6328, BCM6362 and BCM63268.
|
||
|
|
In these SoCs it's possible to control LEDs both as GPIOs or by hardware.
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- compatible : should be "brcm,bcm6858-leds".
|
||
|
|
- #address-cells : must be 1.
|
||
|
|
- #size-cells : must be 0.
|
||
|
|
- reg : BCM6858 LED controller address and size.
|
||
|
|
|
||
|
|
Optional properties:
|
||
|
|
- brcm,serial-led-msb-first : Boolean, msb data come out first on serial data pin
|
||
|
|
Default : false
|
||
|
|
- brcm,serial-led-en-pol : Boolean, serial led polarity (true => active high)
|
||
|
|
Default : false
|
||
|
|
- brcm,serial-led-clk-pol : Boolean, serial clock polarity (true => active high)
|
||
|
|
Default : false
|
||
|
|
- brcm,serial-led-data-ppol : Boolean, serial data polarity (true => active high)
|
||
|
|
Default : false
|
||
|
|
- brcm,serial-shift-inv : Boolean, led test mode
|
||
|
|
Default : false
|
||
|
|
|
||
|
|
Each LED is represented as a sub-node of the brcm,bcm6858-leds device.
|
||
|
|
|
||
|
|
LED sub-node required properties:
|
||
|
|
- reg : LED pin number (only LEDs 0 to 32 are valid).
|
||
|
|
|
||
|
|
LED sub-node optional properties:
|
||
|
|
- label : see Documentation/devicetree/bindings/leds/common.txt
|
||
|
|
- active-low : Boolean, makes LED active low.
|
||
|
|
Default : false
|
||
|
|
|
||
|
|
Examples:
|
||
|
|
BCM6328 with 2 GPIO LEDs
|
||
|
|
leds0: led-controller@ff800800 {
|
||
|
|
compatible = "brcm,bcm6858-leds";
|
||
|
|
#address-cells = <1>;
|
||
|
|
#size-cells = <0>;
|
||
|
|
reg = <0x0 0xff800800 0x0 0xe4>;
|
||
|
|
|
||
|
|
led@2 {
|
||
|
|
reg = <2>;
|
||
|
|
label = "green:inet";
|
||
|
|
};
|
||
|
|
|
||
|
|
led@5 {
|
||
|
|
reg = <5>;
|
||
|
|
label = "red:alarm";
|
||
|
|
};
|
||
|
|
};
|