mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-12-24 20:13:39 +00:00
42 lines
980 B
ReStructuredText
42 lines
980 B
ReStructuredText
|
.. SPDX-License-Identifier: GPL-2.0+
|
||
|
|
|
||
|
|
imxrt1050-evk
|
||
|
|
=============
|
||
|
|
|
||
|
|
How to use U-Boot on NXP i.MXRT1050 EVK
|
||
|
|
---------------------------------------
|
||
|
|
|
||
|
|
- Build U-Boot for i.MXRT1050 EVK:
|
||
|
|
|
||
|
|
.. code-block:: bash
|
||
|
|
|
||
|
|
$ make mrproper
|
||
|
|
$ make imxrt1050-evk_defconfig
|
||
|
|
$ make
|
||
|
|
|
||
|
|
This will generate the SPL image called SPL and the u-boot.img.
|
||
|
|
|
||
|
|
- Flash the SPL image into the micro SD card:
|
||
|
|
|
||
|
|
.. code-block:: bash
|
||
|
|
|
||
|
|
$sudo dd if=SPL of=/dev/sdX bs=1k seek=1 conv=notrunc; sync
|
||
|
|
|
||
|
|
- Flash the u-boot.img image into the micro SD card:
|
||
|
|
|
||
|
|
.. code-block:: bash
|
||
|
|
|
||
|
|
$sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=128 conv=notrunc; sync
|
||
|
|
|
||
|
|
- Jumper settings::
|
||
|
|
|
||
|
|
SW7: 1 0 1 0
|
||
|
|
|
||
|
|
where 0 means bottom position and 1 means top position (from the
|
||
|
|
switch label numbers reference).
|
||
|
|
|
||
|
|
- Connect the USB cable between the EVK and the PC for the console.
|
||
|
|
The USB console connector is the one close the ethernet connector
|
||
|
|
|
||
|
|
- Insert the micro SD card in the board, power it up and U-Boot messages should come up.
|