u-boot/include/configs/octeon_ebb7304.h

/* SPDX-License-Identifier: GPL-2.0+ */
/*
 * Copyright (C) 2019-2020
 * Marvell <www.marvell.com>
 */

#ifndef __CONFIG_H__
#define __CONFIG_H__

#include "octeon_common.h"

#define PHY_ANEG_TIMEOUT	8000	/* PHY needs a longer aneg time */

#endif /* __CONFIG_H__ */
mips: octeon: Add minimal Octeon 3 EBB7304 EVK support This patch adds very basic minimal support for the Marvell Octeon 3 CN73xx based EBB7304 EVK. Please note that the basic Octeon port does not support DDR3/4 initialization yet. To still use U-Boot on with this port, the L2 cache (4MiB) is used as RAM. This way, U-Boot can boot to the prompt on this board. Supported devices: - UART - reset - CFI parallel NOR flash Signed-off-by: Stefan Roese <sr@denx.de> 2020-06-30 10:08:58 +00:00			`/* SPDX-License-Identifier: GPL-2.0+ */`
			`/*`
			`* Copyright (C) 2019-2020`
			`* Marvell <www.marvell.com>`
			`*/`

			`#ifndef __CONFIG_H__`
			`#define __CONFIG_H__`

			`#include "octeon_common.h"`

mips: octeon: ebb7304: Enable ethernet support This patch enables the Kconfig symbols needed for full ethernet support on the EBB7304. Also the PHY autonegotiation timeout is increased, as the default 5 seconds are sometime a bit short. With this, ethernet can be used on this board. Here an example of a tftp load: => tftp ffffffff81000000 big ethernet-mac-nexus@11800e0000000 Waiting for PHY auto negotiation to complete....... done Using ethernet-mac-nexus@11800e0000000 device TFTP from server 192.168.1.5; our IP address is 192.168.1.243 Filename 'big'. Load address: 0xffffffff81000000 Loading: ################################################## 10 MiB 13.2 MiB/s done Bytes transferred = 10485760 (a00000 hex) Signed-off-by: Stefan Roese <sr@denx.de> 2022-04-07 07:11:53 +00:00			`#define PHY_ANEG_TIMEOUT 8000 /* PHY needs a longer aneg time */`

mips: octeon: Add minimal Octeon 3 EBB7304 EVK support This patch adds very basic minimal support for the Marvell Octeon 3 CN73xx based EBB7304 EVK. Please note that the basic Octeon port does not support DDR3/4 initialization yet. To still use U-Boot on with this port, the L2 cache (4MiB) is used as RAM. This way, U-Boot can boot to the prompt on this board. Supported devices: - UART - reset - CFI parallel NOR flash Signed-off-by: Stefan Roese <sr@denx.de> 2020-06-30 10:08:58 +00:00			`#endif /* __CONFIG_H__ */`