u-boot/board/gdsys/a38x/controlcenterdc.c

305 lines
6.8 KiB
C
Raw Normal View History

// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2015 Stefan Roese <sr@denx.de>
* Copyright (C) 2016 Mario Six <mario.six@gdsys.cc>
*/
#include <common.h>
#include <command.h>
#include <dm.h>
#include <event.h>
#include <init.h>
#include <miiphy.h>
#include <net.h>
#include <tpm-v1.h>
#include <asm/global_data.h>
#include <asm/io.h>
#include <asm/arch/cpu.h>
#include <asm-generic/gpio.h>
#include <linux/delay.h>
#include "../drivers/ddr/marvell/a38x/ddr3_init.h"
#include "../arch/arm/mach-mvebu/serdes/a38x/high_speed_env_spec.h"
#include "keyprogram.h"
#include "dt_helpers.h"
#include "hydra.h"
#include "ihs_phys.h"
DECLARE_GLOBAL_DATA_PTR;
#define DB_GP_88F68XX_GPP_OUT_ENA_LOW 0x7fffffff
#define DB_GP_88F68XX_GPP_OUT_ENA_MID 0xffffefff
#define DB_GP_88F68XX_GPP_OUT_VAL_LOW 0x0
#define DB_GP_88F68XX_GPP_OUT_VAL_MID 0x00001000
#define DB_GP_88F68XX_GPP_POL_LOW 0x0
#define DB_GP_88F68XX_GPP_POL_MID 0x0
/*
* Define the DDR layout / topology here in the board file. This will
* be used by the DDR3 init code in the SPL U-Boot version to configure
* the DDR3 controller.
*/
static struct mv_ddr_topology_map ddr_topology_map = {
DEBUG_LEVEL_ERROR,
0x1, /* active interfaces */
/* cs_mask, mirror, dqs_swap, ck_swap X PUPs */
{ { { {0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0} },
SPEED_BIN_DDR_1600K, /* speed_bin */
MV_DDR_DEV_WIDTH_16BIT, /* memory_width */
MV_DDR_DIE_CAP_4GBIT, /* mem_size */
MV_DDR_FREQ_533, /* frequency */
0, 0, /* cas_wl cas_l */
MV_DDR_TEMP_LOW, /* temperature */
MV_DDR_TIM_DEFAULT} }, /* timing */
BUS_MASK_32BIT, /* Busses mask */
MV_DDR_CFG_DEFAULT, /* ddr configuration data source */
NOT_COMBINED, /* ddr twin-die combined */
{ {0} }, /* raw spd data */
{0} /* timing parameters */
};
static struct serdes_map serdes_topology_map[] = {
{SGMII0, SERDES_SPEED_1_25_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{USB3_HOST0, SERDES_SPEED_5_GBPS, SERDES_DEFAULT_MODE, 0, 0},
/* SATA tx polarity is inverted */
{SATA1, SERDES_SPEED_3_GBPS, SERDES_DEFAULT_MODE, 0, 1},
{SGMII2, SERDES_SPEED_1_25_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{DEFAULT_SERDES, SERDES_SPEED_3_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{PEX2, SERDES_SPEED_5_GBPS, PEX_ROOT_COMPLEX_X1, 0, 0}
};
int hws_board_topology_load(struct serdes_map **serdes_map_array, u8 *count)
{
*serdes_map_array = serdes_topology_map;
*count = ARRAY_SIZE(serdes_topology_map);
return 0;
}
void spl_board_init(void)
{
#ifdef CONFIG_SPL_BUILD
uint k;
struct gpio_desc gpio = {};
/* Enable PCIe link 2 */
setbits_32(MVEBU_REGISTER(0x18204), BIT(2));
mdelay(10);
if (!request_gpio_by_name(&gpio, "pca9698@22", 31, "fpga-program-gpio")) {
/* prepare FPGA reconfiguration */
dm_gpio_set_dir_flags(&gpio, GPIOD_IS_OUT);
dm_gpio_set_value(&gpio, 0);
/* give lunatic PCIe clock some time to stabilize */
mdelay(500);
/* start FPGA reconfiguration */
dm_gpio_set_dir_flags(&gpio, GPIOD_IS_IN);
}
/* wait for FPGA done */
if (!request_gpio_by_name(&gpio, "pca9698@22", 19, "fpga-done-gpio")) {
for (k = 0; k < 20; ++k) {
if (dm_gpio_get_value(&gpio)) {
printf("FPGA done after %u rounds\n", k);
break;
}
mdelay(100);
}
}
/* disable FPGA reset */
if (!request_gpio_by_name(&gpio, "gpio@18100", 6, "cpu-to-fpga-reset")) {
dm_gpio_set_dir_flags(&gpio, GPIOD_IS_OUT);
dm_gpio_set_value(&gpio, 1);
}
/* wait for FPGA ready */
if (!request_gpio_by_name(&gpio, "pca9698@22", 27, "fpga-ready-gpio")) {
for (k = 0; k < 2; ++k) {
if (!dm_gpio_get_value(&gpio))
break;
mdelay(100);
}
}
#endif
}
struct mv_ddr_topology_map *mv_ddr_topology_map_get(void)
{
return &ddr_topology_map;
}
int board_early_init_f(void)
{
#ifdef CONFIG_SPL_BUILD
/* Configure MPP */
writel(0x00111111, MVEBU_MPP_BASE + 0x00);
writel(0x40040000, MVEBU_MPP_BASE + 0x04);
writel(0x00466444, MVEBU_MPP_BASE + 0x08);
writel(0x00043300, MVEBU_MPP_BASE + 0x0c);
writel(0x44400000, MVEBU_MPP_BASE + 0x10);
writel(0x20000334, MVEBU_MPP_BASE + 0x14);
writel(0x40000000, MVEBU_MPP_BASE + 0x18);
writel(0x00004444, MVEBU_MPP_BASE + 0x1c);
/* Set GPP Out value */
writel(DB_GP_88F68XX_GPP_OUT_VAL_LOW, MVEBU_GPIO0_BASE + 0x00);
writel(DB_GP_88F68XX_GPP_OUT_VAL_MID, MVEBU_GPIO1_BASE + 0x00);
/* Set GPP Polarity */
writel(DB_GP_88F68XX_GPP_POL_LOW, MVEBU_GPIO0_BASE + 0x0c);
writel(DB_GP_88F68XX_GPP_POL_MID, MVEBU_GPIO1_BASE + 0x0c);
/* Set GPP Out Enable */
writel(DB_GP_88F68XX_GPP_OUT_ENA_LOW, MVEBU_GPIO0_BASE + 0x04);
writel(DB_GP_88F68XX_GPP_OUT_ENA_MID, MVEBU_GPIO1_BASE + 0x04);
#endif
return 0;
}
int board_init(void)
{
/* Address of boot parameters */
gd->bd->bi_boot_params = mvebu_sdram_bar(0) + 0x100;
return 0;
}
#ifndef CONFIG_SPL_BUILD
void init_host_phys(struct mii_dev *bus)
{
uint k;
for (k = 0; k < 2; ++k) {
struct phy_device *phydev;
phydev = phy_find_by_mask(bus, 1 << k);
if (phydev) {
phydev->interface = PHY_INTERFACE_MODE_SGMII;
phy_config(phydev);
}
}
}
int ccdc_eth_init(void)
{
uint k;
uint octo_phy_mask = 0;
int ret;
struct mii_dev *bus;
/* Init SoC's phys */
bus = miiphy_get_dev_by_name("ethernet@34000");
if (bus)
init_host_phys(bus);
bus = miiphy_get_dev_by_name("ethernet@70000");
if (bus)
init_host_phys(bus);
/* Init octo phys */
octo_phy_mask = calculate_octo_phy_mask();
printf("IHS PHYS: %08x", octo_phy_mask);
ret = init_octo_phys(octo_phy_mask);
if (ret)
return ret;
printf("\n");
if (!get_fpga()) {
puts("fpga was NULL\n");
return 1;
}
/* reset all FPGA-QSGMII instances */
for (k = 0; k < 80; ++k)
writel(1 << 31, get_fpga()->qsgmii_port_state[k]);
udelay(100);
for (k = 0; k < 80; ++k)
writel(0, get_fpga()->qsgmii_port_state[k]);
return 0;
}
#endif
int board_late_init(void)
{
#ifndef CONFIG_SPL_BUILD
hydra_initialize();
#endif
return 0;
}
int board_fix_fdt(void *rw_fdt_blob)
{
struct udevice *bus = NULL;
uint k;
char name[64];
int err;
err = uclass_get_device_by_name(UCLASS_I2C, "i2c@11000", &bus);
if (err) {
printf("Could not get I2C bus.\n");
return err;
}
for (k = 0x21; k <= 0x26; k++) {
snprintf(name, 64,
"/soc/internal-regs/i2c@11000/pca9698@%02x", k);
if (!dm_i2c_simple_probe(bus, k))
fdt_disable_by_ofname(rw_fdt_blob, name);
}
return 0;
}
#ifndef CONFIG_SPL_BUILD
static int last_stage_init(void)
{
struct udevice *tpm;
int ret;
if (IS_ENABLED(CONFIG_SPL_BUILD))
return 0;
ccdc_eth_init();
ret = uclass_first_device_err(UCLASS_TPM, &tpm);
if (ret) {
printf("Could not find TPM (ret=%d)\n", ret);
return ret;
}
if (ret || tpm_init(tpm) || tpm1_startup(tpm, TPM_ST_CLEAR) ||
tpm1_continue_self_test(tpm)) {
return 1;
}
mdelay(37);
flush_keys(tpm);
load_and_run_keyprog(tpm);
return 0;
}
EVENT_SPY_SIMPLE(EVT_LAST_STAGE_INIT, last_stage_init);
#endif